u-boot/doc/device-tree-bindings
Tom Rini 1f47e2aca4 Xilinx changes for v2020.07
common:
 - Align ENV_FAT_INTERFACE
 - Fix MAC address source print log
 - Improve based autodetection code
 
 xilinx:
 - Enable netconsole
 
 Microblaze:
 - Setup default ENV_OFFSET/ENV_SECT_SIZE
 
 Zynq:
 - Multiple DT updates/fixes
 - Use DEVICE_TREE environment variable for DTB selection
 - Switch to single zynq configuration
 - Enable NOR flash via DM
 - Minor SPL print removal
 - Enable i2c mux driver
 
 ZynqMP:
 - Print multiboot register
 - Enable cache commands in mini mtest
 - Multiple DT updates/fixes
 - Fix firmware probing when driver is not enabled
 - Specify 3rd backup RAM boot mode in SPL
 - Add SPL support for zcu102 v1.1 and zcu111 revA
 - Redesign debug uart enabling and psu_init delay
 - Enable full u-boot run from EL3
 - Enable u-boot.itb generation without ATF with U-Boot in EL3
 
 Versal:
 - Enable distro default
 - Enable others SPI flashes
 - Enable systems without DDR
 
 Drivers:
 - Gem:
   - Flush memory after freeing
   - Handle mdio bus separately
 - Watchdog:
   - Get rid of unused global data pointer
   - Enable window watchdog timer
 - Serial:
   - Change reinitialization logic in zynq serial driver
 -----BEGIN PGP SIGNATURE-----
 
 iF0EABECAB0WIQQbPNTMvXmYlBPRwx7KSWXLKUoMIQUCXoxw9wAKCRDKSWXLKUoM
 IbQxAKCK23yTy4FoN8oTGTYsbmLOA9kVUQCbBx8lg4nBeA8ihSaAnY+HMDF37YI=
 =Lg54
 -----END PGP SIGNATURE-----

Merge tag 'xilinx-for-v2020.07' of https://gitlab.denx.de/u-boot/custodians/u-boot-microblaze into next

Xilinx changes for v2020.07

common:
- Align ENV_FAT_INTERFACE
- Fix MAC address source print log
- Improve based autodetection code

xilinx:
- Enable netconsole

Microblaze:
- Setup default ENV_OFFSET/ENV_SECT_SIZE

Zynq:
- Multiple DT updates/fixes
- Use DEVICE_TREE environment variable for DTB selection
- Switch to single zynq configuration
- Enable NOR flash via DM
- Minor SPL print removal
- Enable i2c mux driver

ZynqMP:
- Print multiboot register
- Enable cache commands in mini mtest
- Multiple DT updates/fixes
- Fix firmware probing when driver is not enabled
- Specify 3rd backup RAM boot mode in SPL
- Add SPL support for zcu102 v1.1 and zcu111 revA
- Redesign debug uart enabling and psu_init delay
- Enable full u-boot run from EL3
- Enable u-boot.itb generation without ATF with U-Boot in EL3

Versal:
- Enable distro default
- Enable others SPI flashes
- Enable systems without DDR

Drivers:
- Gem:
  - Flush memory after freeing
  - Handle mdio bus separately
- Watchdog:
  - Get rid of unused global data pointer
  - Enable window watchdog timer
- Serial:
  - Change reinitialization logic in zynq serial driver

Signed-off-by: Tom Rini <trini@konsulko.com>
2020-04-07 17:13:35 -04:00
..
adc dt-bindings: Document STM32 ADC DT bindings 2018-08-03 19:53:10 -04:00
arm doc: Remove duplicated documentation directory 2019-06-20 10:57:08 -04:00
ata x86: ivybridge: Add SATA init 2014-11-25 06:34:01 -07:00
axi doc: Remove duplicated documentation directory 2019-06-20 10:57:08 -04:00
board doc: Remove duplicated documentation directory 2019-06-20 10:57:08 -04:00
clock ARM: dts: stm32m1: add reg for pll nodes 2020-02-13 17:26:23 +01:00
cpu doc: Remove duplicated documentation directory 2019-06-20 10:57:08 -04:00
exynos s5p: cpu_info: print "cpu-model" if exists in dts 2015-11-02 10:37:59 +09:00
firmware dt/bindings: add bindings for optee 2018-10-07 10:47:38 -04:00
fpga ARM: socfpga: Description on FPGA bitstream type and file name for Arria 10 2019-05-10 22:48:10 +02:00
gpio gpio/mpc83xx_spisel_boot.c: gpio driver for SPISEL_BOOT signal 2020-03-31 10:06:52 -04:00
gpu tegra124: dts: Add host1x node to provide display information 2015-05-13 09:24:08 -07:00
i2c dm: i2c-gpio: add support for clock stretching 2020-03-16 07:55:06 +01:00
input x86: Add an i8042 device for boards that have it 2015-11-19 20:13:41 -07:00
interrupt-controller x86: Add support for ACPI general-purpose events 2020-02-07 22:46:35 +08:00
leds led: add initial support for bcm6858 2019-04-22 18:13:24 -04:00
mailbox mailbox: Introduce K3 Secure Proxy Driver 2018-09-11 08:32:55 -04:00
memory fdt: Add device tree memory bindings 2018-07-09 09:11:00 -06:00
memory-controller dt-bindings: memory-controller: Introduce J721E DDRSS bindings 2019-10-25 17:33:21 -04:00
memory-controllers ram: stm32mp1: the property st, phy-cal becomes optional 2020-03-24 14:23:30 +01:00
misc Merge tag 'ti-v2020.07-next' of https://gitlab.denx.de/u-boot/custodians/u-boot-ti into next 2020-03-17 11:59:58 -04:00
mmc ARC: dwmmc: Adding DesignWare MMC driver support for ARC devboards 2019-04-18 09:12:38 +03:00
mtd ARM: dts: stm32mp1: DT alignment with kernel v5.4 2020-02-13 17:25:34 +01:00
nand tegra: fdt: Add NAND controller binding and definitions 2012-09-07 13:54:30 -07:00
net dt-bindings: net: dp83867: Remove binding doc from U-Boot tree 2020-03-09 18:11:25 -05:00
pci dm: pci: Allow delaying auto-config until after relocation 2019-12-15 08:52:29 +08:00
pci_endpoint pci_ep: add Cadence PCIe endpoint driver 2019-07-11 10:05:15 -04:00
phy dt-bindings: phy: add a document for MediaTek tphy 2019-10-11 10:10:18 -04:00
pinctrl x86: p2sb: Drop 'apl' prefix 2020-03-05 18:25:21 +08:00
pmic power: pmic: add Ricoh RN5T567 PMIC support 2016-10-07 12:26:15 +02:00
power dt-bindings: ti_sci_pm_domains: Add support for exclusive and shared access 2019-07-26 21:49:23 -04:00
pwm doc: dtbinding: add pwm binding file 2017-05-10 13:37:21 -06:00
ram doc: Remove duplicated documentation directory 2019-06-20 10:57:08 -04:00
regulator dm: regulator: support regulator more state 2019-11-10 20:31:09 +08:00
remoteproc dt-bindings: remoteproc: Add bindings for DSP C66x clusters on TI K3 SoCs 2019-10-11 10:07:34 -04:00
reserved-memory doc: Remove duplicated documentation directory 2019-06-20 10:57:08 -04:00
reset reset: Introduce TI System Control Interface (TI SCI) reset driver 2018-09-11 08:32:55 -04:00
rtc rtc: add support for DS3232 device 2020-01-10 10:25:13 -05:00
serial m68k: add basic set of devicetrees 2019-05-23 23:14:38 -04:00
sound sound: Add codec enable to the sound bindings 2019-08-09 10:01:34 -07:00
spi doc: device-tree-bindings: alignment with v5.2-rc6 for spi-stm32-qspi.txt 2019-07-22 11:04:52 +02:00
spmi drivers: spmi: Add support for Qualcomm SPMI bus driver 2016-04-01 17:18:12 -04:00
sysreset sysreset: Add TI System Control Interface (TI SCI) sysreset driver 2018-09-11 08:32:55 -04:00
thermal thermal: ti-bandgap: Add support for temperature sensor 2017-11-21 08:03:38 -05:00
timer doc: Remove duplicated documentation directory 2019-06-20 10:57:08 -04:00
tpm2 doc: device-tree-bindings: add Sandbox TPMv2.0 module info 2018-05-25 20:13:00 -04:00
usb stm32mp1: add stusb1600 support for DK1 and DK2 board 2019-04-21 10:26:52 +02:00
video fdt: video: omap: add framebuffer and panel bindings 2020-03-03 13:08:14 +05:30
w1 w1: Add driver for i.MX bus master controller 2019-01-01 14:12:18 +01:00
w1-eeprom w1-eeprom: Add support for Maxim DS2502 add only memory 2018-11-16 16:51:55 -05:00
chosen.txt bootcount: add uclass for bootcount 2018-12-10 10:04:44 +01:00
config.txt rockchip: rk3399-puma: add code to allow forcing a power-on reset 2017-11-30 22:59:54 +01:00
README fdt: Add staging area for device tree binding documentation 2012-03-29 08:12:47 +02:00
root.txt fdt: Pass the device serial number through devicetree 2015-06-05 08:32:07 -06:00

Device Tree Bindings Staging Area
=================================

This directory contains device tree bindings for U-Boot.

These follow along with Linux kernel bindings, with a few additions. By
adding the files here, U-Boot patches can clearly show thees additions.
This makes it easier for device tree people to review these additions in
patches sent to the U-Boot mailing list.

The intent IS to commit these files to U-Boot. Hopefully at some point
the files will be stored in another repo (shared with Linux) which is
brought in as needed. Changes here are intended to mirror changes in the
Linux Documentation/devicetree/bindings/ directory.

sjg@chromium.org
17-Jan-12