mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-29 08:01:08 +00:00
c0e2972741
Use driver strength macros instead of hex numbers. - IMX6DQ_DRIVE_STRENGTH - 0x30 - IMX6SDL_DRIVE_STRENGTH - 0x28 Cc: Stefano Babic <sbabic@denx.de> Cc: Matteo Lisi <matteo.lisi@engicam.com> Cc: Michael Trimarchi <michael@amarulasolutions.com> Signed-off-by: Jagan Teki <jagan@amarulasolutions.com> |
||
|---|---|---|
| .. | ||
| icorem6.c | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| README | ||
How to use U-Boot on Engicam i.CoreM6 Solo/DualLite and Quad/Dual Starter Kit: ----------------------------------------------------------------------------- $ make mrproper - Configure U-Boot for Engicam i.CoreM6 Quad/Dual: $ make imx6q_icore_mmc_defconfig - Configure U-Boot for Engicam i.CoreM6 Solo/DualLite: $ make imx6dl_icore_mmc_defconfig - Build U-Boot $ make This will generate the SPL image called SPL and the u-boot-dtb.img. - Flash the SPL image into the micro SD card: sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync - Flash the u-boot-dtb.img image into the micro SD card: sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync - Jumper settings: MMC Boot: JM3 Closed - Connect the Serial cable between the Starter Kit and the PC for the console. (J28 is the Linux Serial console connector) - Insert the micro SD card in the board, power it up and U-Boot messages should come up.