mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-17 18:28:55 +00:00
3a21773129
SolidRun has designed the Hummingboard board based on mx6q/dl/solo. Add the initial support for the mx6 solo variant. More information about this hardware can be found at: http://imx.solid-run.com/wiki/index.php?title=Carrier-One_Hardware (Carrier-One was the previous name of Hummingboard). Based on the work from Jon Nettleton <jon.nettleton@gmail.com>. Signed-off-by: Jon Nettleton <jon.nettleton@gmail.com> Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
40 lines
1.3 KiB
Text
40 lines
1.3 KiB
Text
U-Boot for SolidRun Hummingboard
|
|
--------------------------------
|
|
|
|
This file contains information for the port of U-Boot to the Hummingboard.
|
|
|
|
For more details about Hummingboard, please refer to:
|
|
http://imx.solid-run.com/wiki/index.php?title=Carrier-One_Hardware
|
|
|
|
(Carrier-One was the previous name of Hummingboard).
|
|
|
|
Building U-boot for Hummingboard
|
|
--------------------------------
|
|
|
|
To build U-Boot for the Hummingboard Solo version:
|
|
|
|
$ make hummingboard_solo_config
|
|
$ make
|
|
|
|
Flashing U-boot into the SD card
|
|
--------------------------------
|
|
|
|
- After the 'make' command completes, the generated 'u-boot.imx' binary must be
|
|
flashed into the SD card:
|
|
|
|
$ sudo dd if=u-boot.imx of=/dev/mmcblk0 bs=1k seek=1; sync
|
|
|
|
(Note - the SD card node may vary, so adjust this as needed).
|
|
|
|
Also, a more detailed explanation on how to format the SD card is available
|
|
at doc/README.imximage.
|
|
|
|
- Insert the micro SD card into the slot located in the bottom of the board
|
|
|
|
- Connect a 3.3V USB to serial converter cable to the host PC. The MX6 UART
|
|
signals are available in the 26 pin connector as shown at:
|
|
http://imx.solid-run.com/wiki/index.php?title=Carrier-One_Hardware
|
|
(Check for "26 pin header layout").
|
|
|
|
- Power up the board via USB cable (CON201) and U-boot messages will appear in
|
|
the serial console.
|