u-boot/arch/arm/mach-stm32mp/Kconfig
Lokesh Vutla acf1500138 arm: v7: Kconfig: Rename CPU_V7 as CPU_V7A
Currently CPU_V7 kconfig symbol supports only ARMv7A architectures under
armv7 folder. This led to a misconception of creating separate folders
for armv7m and armv7r. There is no reason to create separate folder for
other armv7 based architectures when it can co-exist with few Kconfig
symbols.

As a first step towards a common folder, rename CPU_V7 as CPUV7A. Later
separate Kconfig symbols can be added for CPU_V7R and CPU_V7M and
can co exist in the same folder.

Reviewed-by: Tom Rini <trini@konsulko.com>
Tested-by: Michal Simek <michal.simek@xilinx.com>
Suggested-by: Alexander Graf <agraf@suse.de>
Signed-off-by: Lokesh Vutla <lokeshvutla@ti.com>
2018-05-07 15:53:24 -04:00

57 lines
1.2 KiB
Text

if ARCH_STM32MP
config SPL
select SPL_BOARD_INIT
select SPL_CLK
select SPL_DM
select SPL_DM_SEQ_ALIAS
select SPL_FRAMEWORK
select SPL_GPIO_SUPPORT
select SPL_LIBCOMMON_SUPPORT
select SPL_LIBGENERIC_SUPPORT
select SPL_OF_CONTROL
select SPL_OF_TRANSLATE
select SPL_PINCTRL
select SPL_REGMAP
select SPL_RESET_SUPPORT
select SPL_SERIAL_SUPPORT
select SPL_SYSCON
select SPL_DRIVERS_MISC_SUPPORT
imply SPL_LIBDISK_SUPPORT
config SYS_SOC
default "stm32mp"
config TARGET_STM32MP1
bool "Support stm32mp1xx"
select ARCH_SUPPORT_PSCI
select CPU_V7A
select CPU_V7_HAS_NONSEC
select CPU_V7_HAS_VIRT
select PINCTRL_STM32
select STM32_RESET
select SYS_ARCH_TIMER
select SYSRESET_SYSCON
help
target STMicroelectronics SOC STM32MP1 family
STMicroelectronics MPU with core ARMv7
config SYS_TEXT_BASE
prompt "U-Boot base address"
default 0xC0100000
help
configure the U-Boot base address
when DDR driver is used:
DDR + 1MB (0xC0100000)
config SYS_MMCSD_RAW_MODE_U_BOOT_PARTITION_MMC2
hex "Partition on MMC2 to use to load U-Boot from"
depends on SYS_MMCSD_RAW_MODE_U_BOOT_USE_PARTITION
default 1
help
Partition on the second MMC to load U-Boot from when the MMC is being
used in raw mode
source "board/st/stm32mp1/Kconfig"
endif