mirror of
https://github.com/AsahiLinux/u-boot
synced 2025-02-18 06:58:54 +00:00
2ee6c52e22
MDIO clock needs to be initialized in u-boot code for SoCs having FMAN-v3(v3H or v3L) controller due to below reasons -On SoCs that have FMAN-v3H like B4860, default value of MDIO_CLK_DIV bits in mdio_stat(mdio_cfg) register generates mdio clock too high (much higher than 2.5MHz), violating the IEEE specs. -On SOCs that have FMAN-v3L like T1040, default value of MDIO_CLK_DIV bits is zero, so MDIO clock is disabled. So, for proper functioninig of MDIO, MDIO_CLK_DIV bits needs to be properly initialized. Also this type of initialization is generally done in PBI(pre-bootloader) phase using rcw.But for chips like T1040 which support deep-sleep, such type of initialization cannot be done in PBI phase due to the limitation that during deep-sleep resume, FMAN (MDIO) registers are not accessible in PBI phase. So, mdio clock initailization must be done as part of u-boot. This initialization code is implemented in memac_phy.c which gets compiled only for SoCs having FMANv3, so no extra compilation flag is required. Signed-off-by: Priyanka Jain <Priyanka.Jain@freescale.com> Reviewed-by: York Sun <yorksun@freescale.com> |
||
|---|---|---|
| .. | ||
| bios_emulator | ||
| block | ||
| bootcount | ||
| core | ||
| crypto | ||
| ddr/fsl | ||
| demo | ||
| dfu | ||
| dma | ||
| fpga | ||
| gpio | ||
| hwmon | ||
| i2c | ||
| input | ||
| misc | ||
| mmc | ||
| mtd | ||
| net | ||
| pci | ||
| pcmcia | ||
| power | ||
| qe | ||
| rtc | ||
| serial | ||
| sound | ||
| spi | ||
| tpm | ||
| twserial | ||
| usb | ||
| video | ||
| watchdog | ||
| Makefile | ||