Commit graph

4 commits

Author SHA1 Message Date
Simon Goldschmidt
ed784ac382 mtd: rawnand: denali: add reset handling
This adds reset handling to the devicetree-enabled Denali NAND driver.

For backwards compatibility, only a warning is printed when failing to
get reset handles.

Signed-off-by: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>
2019-04-17 22:20:16 +02:00
Masahiro Yamada
8ccfbfb3e1 mtd: rawnand: denali: optimize timing parameters for data interface
Based on Linux commit 1dfac31a5a63ac04a9b5fbc3f5105a586560f191

This commit improves the ->setup_data_interface() hook.

The denali_setup_data_interface() needs the frequency of clk_x
and the ratio of clk_x / clk.

The latter is currently hardcoded in the driver, like this:

  #define DENALI_CLK_X_MULT       6

The IP datasheet requires that clk_x / clk be 4, 5, or 6.  I just
chose 6 because it is the most defensive value, but it is not optimal.
By getting the clock rate of both "clk" and "clk_x", the driver can
compute the timing values more precisely.

To not break the existing platforms, the fallback value, 50 MHz is
provided.  It is true for all upstreamed platforms.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
2018-12-29 11:38:37 +09:00
Masahiro Yamada
a13fe7afe9 mtd: rawnand: denali_dt: add more clocks based on IP datasheet
Based on Linux commit 6f1fe97bec349a1fd6c5a8c7c5998d759fe721d5

Currently, denali_dt.c requires a single anonymous clock, but
the Denali User's Guide requires three clocks for this IP:

 - clk: controller core clock

 - clk_x: bus interface clock

 - ecc_clk: clock at which ECC circuitry is run

This commit supports these named clocks to represent the real hardware.

For the backward compatibility, the driver still accepts a single clock
just as before.  The clk_x_rate is taken from the clock driver again if
the named clock "clk_x" is available.  This will happen only for future
DT, hence the existing DT files are not affected.

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
2018-12-29 11:38:36 +09:00
Miquel Raynal
a430fa06a4 mtd: move NAND files into a raw/ subdirectory
NAND flavors, like serial and parallel, have a lot in common and would
benefit to share code. Let's move raw (parallel) NAND specific code in a
raw/ subdirectory, to ease the addition of a core file in nand/ and the
introduction of a spi/ subdirectory specific to SPI NANDs.

Signed-off-by: Miquel Raynal <miquel.raynal@bootlin.com>
2018-09-20 20:10:49 +05:30
Renamed from drivers/mtd/nand/denali_dt.c (Browse further)