u-boot/board/bosch/guardian/board.c

349 lines
7.8 KiB
C
Raw Normal View History

// SPDX-License-Identifier: GPL-2.0+
/*
* board.c
*
* Board functions for Bosch Guardian
*
* Copyright (C) 2011, Texas Instruments, Incorporated - http://www.ti.com/
* Copyright (C) 2018 Robert Bosch Power Tools GmbH
*/
#include <common.h>
#include <dm.h>
#include <env_internal.h>
#include <errno.h>
#include <i2c.h>
#include <led.h>
#include <panel.h>
#include <linux/delay.h>
#include <asm/global_data.h>
#include <power/tps65217.h>
#include <spl.h>
#include <watchdog.h>
#include <asm/arch/clock.h>
#include <asm/arch/cpu.h>
#include <asm/arch/ddr_defs.h>
#include <asm/arch/gpio.h>
#include <asm/arch/hardware.h>
#include <asm/arch/mem-guardian.h>
#include <asm/arch/omap.h>
#include <asm/arch/sys_proto.h>
#include <asm/emif.h>
#include <asm/gpio.h>
#include <asm/io.h>
#include <jffs2/load_kernel.h>
#include <mtd.h>
#include <nand.h>
#include <video.h>
#include <video_console.h>
#include "board.h"
DECLARE_GLOBAL_DATA_PTR;
#if !CONFIG_IS_ENABLED(SKIP_LOWLEVEL_INIT)
static struct ctrl_dev *cdev = (struct ctrl_dev *)CTRL_DEVICE_BASE;
static const struct ddr_data ddr3_data = {
.datardsratio0 = MT41K128M16JT125K_RD_DQS,
.datawdsratio0 = MT41K128M16JT125K_WR_DQS,
.datafwsratio0 = MT41K128M16JT125K_PHY_FIFO_WE,
.datawrsratio0 = MT41K128M16JT125K_PHY_WR_DATA,
};
static const struct cmd_control ddr3_cmd_ctrl_data = {
.cmd0csratio = MT41K128M16JT125K_RATIO,
.cmd0iclkout = MT41K128M16JT125K_INVERT_CLKOUT,
.cmd1csratio = MT41K128M16JT125K_RATIO,
.cmd1iclkout = MT41K128M16JT125K_INVERT_CLKOUT,
.cmd2csratio = MT41K128M16JT125K_RATIO,
.cmd2iclkout = MT41K128M16JT125K_INVERT_CLKOUT,
};
static struct emif_regs ddr3_emif_reg_data = {
.sdram_config = MT41K128M16JT125K_EMIF_SDCFG,
.ref_ctrl = MT41K128M16JT125K_EMIF_SDREF,
.sdram_tim1 = MT41K128M16JT125K_EMIF_TIM1,
.sdram_tim2 = MT41K128M16JT125K_EMIF_TIM2,
.sdram_tim3 = MT41K128M16JT125K_EMIF_TIM3,
.zq_config = MT41K128M16JT125K_ZQ_CFG,
.emif_ddr_phy_ctlr_1 = MT41K128M16JT125K_EMIF_READ_LATENCY,
};
#define OSC (V_OSCK / 1000000)
const struct dpll_params dpll_ddr = {
400, OSC - 1, 1, -1, -1, -1, -1};
void am33xx_spl_board_init(void)
{
int mpu_vdd;
int usb_cur_lim;
/* Get the frequency */
dpll_mpu_opp100.m = am335x_get_efuse_mpu_max_freq(cdev);
/* Initialize for Power Management */
if (power_tps65217_init(0))
return;
/*
* Increase USB current limit to 1300mA or 1800mA and set
* the MPU voltage controller as needed.
*/
if (dpll_mpu_opp100.m == MPUPLL_M_1000) {
usb_cur_lim = TPS65217_USB_INPUT_CUR_LIMIT_1800MA;
mpu_vdd = TPS65217_DCDC_VOLT_SEL_1325MV;
} else {
usb_cur_lim = TPS65217_USB_INPUT_CUR_LIMIT_1300MA;
mpu_vdd = TPS65217_DCDC_VOLT_SEL_1275MV;
}
if (tps65217_reg_write(TPS65217_PROT_LEVEL_NONE,
TPS65217_POWER_PATH,
usb_cur_lim,
TPS65217_USB_INPUT_CUR_LIMIT_MASK))
puts("tps65217_reg_write failure\n");
/* Set DCDC3 (CORE) voltage to 1.125V */
if (tps65217_voltage_update(TPS65217_DEFDCDC3,
TPS65217_DCDC_VOLT_SEL_1125MV)) {
puts("tps65217_voltage_update failure\n");
return;
}
/* Set CORE Frequencies to OPP100 */
do_setup_dpll(&dpll_core_regs, &dpll_core_opp100);
/* Set DCDC2 (MPU) voltage */
if (tps65217_voltage_update(TPS65217_DEFDCDC2, mpu_vdd)) {
puts("tps65217_voltage_update failure\n");
return;
}
/*
* Set LDO3 to 1.8V and LDO4 to 3.3V
*/
if (tps65217_reg_write(TPS65217_PROT_LEVEL_2,
TPS65217_DEFLS1,
TPS65217_LDO_VOLTAGE_OUT_1_8,
TPS65217_LDO_MASK))
puts("tps65217_reg_write failure\n");
if (tps65217_reg_write(TPS65217_PROT_LEVEL_2,
TPS65217_DEFLS2,
TPS65217_LDO_VOLTAGE_OUT_3_3,
TPS65217_LDO_MASK))
puts("tps65217_reg_write failure\n");
/* Set MPU Frequency to what we detected now that voltages are set */
do_setup_dpll(&dpll_mpu_regs, &dpll_mpu_opp100);
}
const struct dpll_params *get_dpll_ddr_params(void)
{
enable_i2c0_pin_mux();
return &dpll_ddr;
}
void set_uart_mux_conf(void)
{
enable_uart0_pin_mux();
}
void set_mux_conf_regs(void)
{
enable_board_pin_mux();
}
const struct ctrl_ioregs ioregs = {
.cm0ioctl = MT41K128M16JT125K_IOCTRL_VALUE,
.cm1ioctl = MT41K128M16JT125K_IOCTRL_VALUE,
.cm2ioctl = MT41K128M16JT125K_IOCTRL_VALUE,
.dt0ioctl = MT41K128M16JT125K_IOCTRL_VALUE,
.dt1ioctl = MT41K128M16JT125K_IOCTRL_VALUE,
};
void sdram_init(void)
{
config_ddr(400, &ioregs,
&ddr3_data,
&ddr3_cmd_ctrl_data,
&ddr3_emif_reg_data, 0);
}
#endif
int board_init(void)
{
save_omap_boot_params();
#if defined(CONFIG_HW_WATCHDOG)
hw_watchdog_init();
#endif
gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE + 0x100;
#ifdef CONFIG_MTD_RAW_NAND
gpmc_init();
#endif
return 0;
}
#ifdef CONFIG_BOARD_LATE_INIT
static void set_bootmode_env(void)
{
char *boot_mode_gpio = "gpio@44e07000_14";
int ret;
struct gpio_desc boot_mode_desc;
ret = dm_gpio_lookup_name(boot_mode_gpio, &boot_mode_desc);
if (ret) {
printf("%s is not found\n", boot_mode_gpio);
goto err;
}
ret = dm_gpio_request(&boot_mode_desc, "setup_bootmode_env");
if (ret && ret != -EBUSY) {
printf("requesting gpio: %s failed\n", boot_mode_gpio);
goto err;
}
dm_gpio_set_dir_flags(&boot_mode_desc, GPIOD_IS_IN);
udelay(10);
ret = dm_gpio_get_value(&boot_mode_desc);
if (ret == 0) {
env_set("swi_status", "1");
} else if (ret == 1) {
env_set("swi_status", "0");
} else {
printf("swi status gpio error\n");
goto err;
}
return;
err:
env_set("swi_status", "err");
}
void lcdbacklight_en(void)
{
unsigned long brightness = env_get_ulong("backlight_brightness", 10, 50);
if (brightness > 99 || brightness == 0)
brightness = 99;
/*
* Brightness range:
* WLEDCTRL2 DUTY[6:0]
*
* 000 0000b = 1%
* 000 0001b = 2%
* ...
* 110 0010b = 99%
* 110 0011b = 100%
*
*/
tps65217_reg_write(TPS65217_PROT_LEVEL_NONE, TPS65217_WLEDCTRL2,
brightness, 0xFF);
tps65217_reg_write(TPS65217_PROT_LEVEL_NONE, TPS65217_WLEDCTRL1,
brightness != 0 ? 0x0A : 0x02, 0xFF);
}
#if IS_ENABLED(CONFIG_AM335X_LCD)
static void splash_screen(void)
{
struct udevice *video_dev;
struct udevice *console_dev;
struct video_priv *vid_priv;
struct mtd_info *mtd;
size_t len;
int ret;
struct mtd_device *mtd_dev;
struct part_info *part;
u8 pnum;
ret = uclass_get_device(UCLASS_VIDEO, 0, &video_dev);
if (ret != 0) {
debug("video device not found\n");
goto exit;
}
vid_priv = dev_get_uclass_priv(video_dev);
mtdparts_init();
if (find_dev_and_part(SPLASH_SCREEN_NAND_PART, &mtd_dev, &pnum, &part)) {
debug("Could not find nand partition\n");
goto splash_screen_text;
}
mtd = get_nand_dev_by_index(mtd_dev->id->num);
if (!mtd) {
debug("MTD partition is not valid\n");
goto splash_screen_text;
}
len = SPLASH_SCREEN_BMP_FILE_SIZE;
ret = nand_read_skip_bad(mtd, part->offset, &len, NULL,
SPLASH_SCREEN_BMP_FILE_SIZE,
(u_char *)SPLASH_SCREEN_BMP_LOAD_ADDR);
if (ret != 0) {
debug("Reading NAND partition failed\n");
goto splash_screen_text;
}
ret = video_bmp_display(video_dev, SPLASH_SCREEN_BMP_LOAD_ADDR, 0, 0, false);
if (ret != 0) {
debug("No valid bmp image found!!\n");
goto splash_screen_text;
} else {
goto exit;
}
splash_screen_text:
vid_priv->colour_fg = CONSOLE_COLOR_RED;
vid_priv->colour_bg = CONSOLE_COLOR_BLACK;
if (!uclass_first_device_err(UCLASS_VIDEO_CONSOLE, &console_dev)) {
debug("Found console\n");
vidconsole_position_cursor(console_dev, 17, 7);
vidconsole_put_string(console_dev, SPLASH_SCREEN_TEXT);
} else {
debug("No console device found\n");
}
exit:
return;
}
#endif /* CONFIG_AM335X_LCD */
int board_late_init(void)
{
int ret;
struct udevice *cdev;
set_bootmode_env();
ret = uclass_get_device(UCLASS_PANEL, 0, &cdev);
if (ret) {
debug("video panel not found: %d\n", ret);
return ret;
}
/* Initialize to enable backlight */
if (power_tps65217_init(0))
return 0;
lcdbacklight_en();
if (IS_ENABLED(CONFIG_AM335X_LCD))
splash_screen();
return 0;
}
#endif /* CONFIG_BOARD_LATE_INIT */