u-boot/board/compulab/cl-som-am57x/Makefile

#
# Makefile
#
# (C) Copyright 2016 CompuLab, Ltd. <www.compulab.co.il>
#
# Author: Dmitry Lifshitz <lifshitz@compulab.co.il>
#
# SPDX-License-Identifier:     GPL-2.0+
#

ifdef CONFIG_SPL_BUILD
obj-y	+= spl.o mux.o
else
obj-y	+= cl-som-am57x.o mux.o
endif

obj-$(CONFIG_DRIVER_TI_CPSW)	+= eth.o
arm: am57xx: cl-som-am57x: add initial board support Features supported : * Serial console * SPI Flash * MMC/SD Card * eMMC storage * SATA * PCA9555 - GPIO expander over I2C5 bus * USB Use spl alternate boot device feature to define fallback to the main boot device as it is defined by hardware. Signed-off-by: Dmitry Lifshitz <lifshitz@compulab.co.il> [uri.mashiach@compulab.co.il: Adjust to v2016.11] Signed-off-by: Uri Mashiach <uri.mashiach@compulab.co.il> Acked-by: Igor Grinberg <grinberg@compulab.co.il> 2016-12-28 16:28:33 +00:00			`#`
			`# Makefile`
			`#`
			`# (C) Copyright 2016 CompuLab, Ltd. <www.compulab.co.il>`
			`#`
			`# Author: Dmitry Lifshitz <lifshitz@compulab.co.il>`
			`#`
			`# SPDX-License-Identifier: GPL-2.0+`
			`#`

			`ifdef CONFIG_SPL_BUILD`
			`obj-y += spl.o mux.o`
			`else`
			`obj-y += cl-som-am57x.o mux.o`
			`endif`
arm: am57xx: cl-som-am57x: add ETH support Add MAC support. Use PHY, connected to RGMII1 as a default Eth adapter, by appropriate setting of 'cpsw_data.active_slave'. 'cpsw_phy' env variable can override this setting. Set the MAC addresses in the U-Boot environment. The addresses are retrieved from the on-board EEPROM or from the SOC's MAC fuses. Set the following PHYs RGMII clock delays: - Enable RX delay - Disable TX delay Signed-off-by: Dmitry Lifshitz <lifshitz@compulab.co.il> [uri.mashiach@compulab.co.il: add RGMII clock delays] Signed-off-by: Uri Mashiach <uri.mashiach@compulab.co.il> Acked-by: Igor Grinberg <grinberg@compulab.co.il> Reviewed-by: Tom Rini <trini@konsulko.com> 2016-12-28 16:28:35 +00:00
			`obj-$(CONFIG_DRIVER_TI_CPSW) += eth.o`