mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-06 05:04:26 +00:00
8162e8ac70
The K3 System Controller driver is used for loading and starting the System Firmware, and is used only on R5 SPL. It need not be enabled and built for the A53 U-Boot and SPL, so disable it from both the GP and HS AM65x A53 defconfigs. While at this, also remove the unneeded CONFIG_SPL_REMOTEPROC and CONFIG_CMD_REMOTEPROC as no remoteprocs are now loaded from A53 SPL. Signed-off-by: Suman Anna <s-anna@ti.com> Reviewed-by: Lokesh Vutla <lokeshvutla@ti.com>
88 lines
2.2 KiB
Text
88 lines
2.2 KiB
Text
CONFIG_ARM=y
|
|
CONFIG_ARCH_K3=y
|
|
CONFIG_SPL_LIBCOMMON_SUPPORT=y
|
|
CONFIG_SPL_LIBGENERIC_SUPPORT=y
|
|
CONFIG_SYS_MALLOC_F_LEN=0x8000
|
|
CONFIG_SOC_K3_AM6=y
|
|
CONFIG_TARGET_AM654_A53_EVM=y
|
|
CONFIG_SPL_MMC_SUPPORT=y
|
|
CONFIG_SPL_SERIAL_SUPPORT=y
|
|
CONFIG_SPL_DRIVERS_MISC_SUPPORT=y
|
|
CONFIG_NR_DRAM_BANKS=2
|
|
CONFIG_SPL_STACK_R_ADDR=0x82000000
|
|
CONFIG_SPL_FS_FAT=y
|
|
CONFIG_SPL_LIBDISK_SUPPORT=y
|
|
CONFIG_DISTRO_DEFAULTS=y
|
|
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
|
|
CONFIG_SPL_LOAD_FIT=y
|
|
CONFIG_OF_BOARD_SETUP=y
|
|
CONFIG_BOOTCOMMAND="run findfdt; run envboot; run init_${boot}; run get_kern_${boot}; run get_fdt_${boot}; run get_overlay_${boot}; run run_kern"
|
|
# CONFIG_DISPLAY_CPUINFO is not set
|
|
CONFIG_SPL_TEXT_BASE=0x80080000
|
|
CONFIG_SPL_SYS_MALLOC_SIMPLE=y
|
|
CONFIG_SPL_STACK_R=y
|
|
CONFIG_SPL_SEPARATE_BSS=y
|
|
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_USE_SECTOR=y
|
|
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0x1400
|
|
CONFIG_SPL_I2C_SUPPORT=y
|
|
CONFIG_SPL_DM_MAILBOX=y
|
|
CONFIG_SPL_DM_RESET=y
|
|
CONFIG_SPL_POWER_DOMAIN=y
|
|
CONFIG_SPL_YMODEM_SUPPORT=y
|
|
CONFIG_CMD_ASKENV=y
|
|
# CONFIG_CMD_FLASH is not set
|
|
CONFIG_CMD_GPT=y
|
|
CONFIG_CMD_I2C=y
|
|
CONFIG_CMD_MMC=y
|
|
# CONFIG_CMD_SETEXPR is not set
|
|
CONFIG_CMD_TIME=y
|
|
# CONFIG_ISO_PARTITION is not set
|
|
CONFIG_OF_CONTROL=y
|
|
CONFIG_SPL_OF_CONTROL=y
|
|
CONFIG_DEFAULT_DEVICE_TREE="k3-am654-base-board"
|
|
CONFIG_SPL_MULTI_DTB_FIT=y
|
|
CONFIG_SPL_MULTI_DTB_FIT_NO_COMPRESSION=y
|
|
CONFIG_ENV_IS_IN_MMC=y
|
|
CONFIG_NET_RANDOM_ETHADDR=y
|
|
CONFIG_DM=y
|
|
CONFIG_SPL_DM=y
|
|
CONFIG_SPL_DM_SEQ_ALIAS=y
|
|
CONFIG_REGMAP=y
|
|
CONFIG_SPL_REGMAP=y
|
|
CONFIG_CLK=y
|
|
CONFIG_SPL_CLK=y
|
|
CONFIG_CLK_TI_SCI=y
|
|
CONFIG_DMA_CHANNELS=y
|
|
CONFIG_TI_K3_NAVSS_UDMA=y
|
|
CONFIG_TI_SCI_PROTOCOL=y
|
|
CONFIG_DM_GPIO=y
|
|
CONFIG_DM_PCA953X=y
|
|
CONFIG_DM_I2C=y
|
|
CONFIG_I2C_SET_DEFAULT_BUS_NUM=y
|
|
CONFIG_SYS_I2C_OMAP24XX=y
|
|
CONFIG_DM_MAILBOX=y
|
|
CONFIG_K3_SEC_PROXY=y
|
|
CONFIG_DM_MMC=y
|
|
CONFIG_MMC_SDHCI=y
|
|
CONFIG_MMC_SDHCI_AM654=y
|
|
CONFIG_PHY_TI=y
|
|
CONFIG_PHY_FIXED=y
|
|
CONFIG_DM_ETH=y
|
|
CONFIG_TI_AM65_CPSW_NUSS=y
|
|
CONFIG_PHY=y
|
|
CONFIG_PINCTRL=y
|
|
# CONFIG_PINCTRL_GENERIC is not set
|
|
CONFIG_SPL_PINCTRL=y
|
|
# CONFIG_SPL_PINCTRL_GENERIC is not set
|
|
CONFIG_PINCTRL_SINGLE=y
|
|
CONFIG_POWER_DOMAIN=y
|
|
CONFIG_TI_SCI_POWER_DOMAIN=y
|
|
CONFIG_DM_RESET=y
|
|
CONFIG_RESET_TI_SCI=y
|
|
CONFIG_DM_SERIAL=y
|
|
CONFIG_SOC_TI=y
|
|
CONFIG_SYSRESET=y
|
|
CONFIG_SPL_SYSRESET=y
|
|
CONFIG_SYSRESET_TI_SCI=y
|
|
CONFIG_FAT_WRITE=y
|
|
CONFIG_OF_LIBFDT_OVERLAY=y
|