u-boot/doc/SPI/README.sandbox-spi
AKASHI Takahiro 5e61c4e89d sandbox: update documents regarding spi_sf
Since the commit 1289e96797 ("sandbox: spi: Drop command-line SPI
option"), "--spi_sf" command line option is no longer supported.

So update the following documents to sync them up with the change.
	doc/arch/sandbox.rst
	doc/SPI/README.sandbox-spi

Signed-off-by: AKASHI Takahiro <takahiro.akashi@linaro.org>
Reviewed-by: Simon Glass <sjg@chromium.org>
2020-05-29 20:55:45 -06:00

42 lines
1.1 KiB
Text

Sandbox SPI/SPI Flash Implementation
====================================
U-Boot supports SPI and SPI flash emulation in sandbox. This must be enabled
via a device tree.
For example:
spi@0 {
#address-cells = <1>;
#size-cells = <0>;
reg = <0 1>;
compatible = "sandbox,spi";
cs-gpios = <0>, <&gpio_a 0>;
spi.bin@0 {
reg = <0>;
compatible = "spansion,m25p16", "jedec,spi-nor";
spi-max-frequency = <40000000>;
sandbox,filename = "spi.bin";
};
};
Supported chips are W25Q16 (2MB), W25Q32 (4MB) and W25Q128 (16MB). Once
U-Boot it started you can use 'sf' commands as normal. For example:
$ dd if=/dev/zero of=spi.bin bs=1M count=2
$ u-boot -T
Since the SPI bus is fully implemented as well as the SPI flash connected to
it, you can also use low-level SPI commands to access the flash. For example
this reads the device ID from the emulated chip:
=> sspi 0 32 9f
SF: Detected m25p16 with page size 256 Bytes, erase size 64 KiB, total 2 MiB
FF202015
Simon Glass
sjg@chromium.org
7/11/2013
Note that the sandbox SPI implementation was written by Mike Frysinger
<vapier@gentoo.org>.