u-boot/board/gdsys/a38x/controlcenterdc.c
Marek Behún 90bcc3d38d driver/ddr: Add support for setting timing in hws_topology_map
The DDR3 training code for Marvell A38X currently computes 1t timing
when given board topology map of the Turris Omnia, but Omnia needs 2t.

This patch adds support for enforcing the 2t timing in struct
hws_topology_map, through a new enum hws_timing, which can assume
following values:
  HWS_TIM_DEFAULT - default behaviour, compute whether to enable 2t
                    from the number of CSs
  HWS_TIM_1T      - enforce 1t
  HWS_TIM_2T      - enforce 2t

This patch also sets all the board topology maps (db-88f6820-amc,
db-88f6820-gp, controlcenterdc and clearfog) to have timing set to
HWS_TIM_DEFAULT.

Signed-off-by: Marek Behun <marek.behun@nic.cz>
Reviewed-by: Stefan Roese <sr@denx.de>
Signed-off-by: Stefan Roese <sr@denx.de>
2017-07-12 06:56:48 +02:00

280 lines
6.2 KiB
C

/*
* Copyright (C) 2015 Stefan Roese <sr@denx.de>
* Copyright (C) 2016 Mario Six <mario.six@gdsys.cc>
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <dm.h>
#include <miiphy.h>
#include <tpm.h>
#include <asm/io.h>
#include <asm/arch/cpu.h>
#include <asm-generic/gpio.h>
#include "../drivers/ddr/marvell/a38x/ddr3_a38x_topology.h"
#include "../arch/arm/mach-mvebu/serdes/a38x/high_speed_env_spec.h"
#include "keyprogram.h"
#include "dt_helpers.h"
#include "hydra.h"
#include "ihs_phys.h"
DECLARE_GLOBAL_DATA_PTR;
#define ETH_PHY_CTRL_REG 0
#define ETH_PHY_CTRL_POWER_DOWN_BIT 11
#define ETH_PHY_CTRL_POWER_DOWN_MASK (1 << ETH_PHY_CTRL_POWER_DOWN_BIT)
#define DB_GP_88F68XX_GPP_OUT_ENA_LOW 0x7fffffff
#define DB_GP_88F68XX_GPP_OUT_ENA_MID 0xffffefff
#define DB_GP_88F68XX_GPP_OUT_VAL_LOW 0x0
#define DB_GP_88F68XX_GPP_OUT_VAL_MID 0x00001000
#define DB_GP_88F68XX_GPP_POL_LOW 0x0
#define DB_GP_88F68XX_GPP_POL_MID 0x0
/*
* Define the DDR layout / topology here in the board file. This will
* be used by the DDR3 init code in the SPL U-Boot version to configure
* the DDR3 controller.
*/
static struct hws_topology_map ddr_topology_map = {
0x1, /* active interfaces */
/* cs_mask, mirror, dqs_swap, ck_swap X PUPs */
{ { { {0x1, 0, 0, 0},
{0x1, 0, 0, 0},
{0x1, 0, 0, 0},
{0x1, 0, 0, 0},
{0x1, 0, 0, 0} },
SPEED_BIN_DDR_1600K, /* speed_bin */
BUS_WIDTH_16, /* memory_width */
MEM_4G, /* mem_size */
DDR_FREQ_533, /* frequency */
0, 0, /* cas_l cas_wl */
HWS_TEMP_LOW, /* temperature */
HWS_TIM_DEFAULT} }, /* timing */
5, /* Num Of Bus Per Interface*/
BUS_MASK_32BIT /* Busses mask */
};
static struct serdes_map serdes_topology_map[] = {
{SGMII0, SERDES_SPEED_1_25_GBPS, SERDES_DEFAULT_MODE, 0, 0},
{USB3_HOST0, SERDES_SPEED_5_GBPS, SERDES_DEFAULT_MODE, 0, 0},
/* SATA tx polarity is inverted */
{SATA1, SERDES_SPEED_3_GBPS, SERDES_DEFAULT_MODE, 0, 1},
{SGMII2, SERDES_SPEED_1_25_GBPS, SERDES_DEFAULT_MODE, 0, 0},
{DEFAULT_SERDES, SERDES_SPEED_3_GBPS, SERDES_DEFAULT_MODE, 0, 0},
{PEX2, SERDES_SPEED_5_GBPS, PEX_ROOT_COMPLEX_X1, 0, 0}
};
int hws_board_topology_load(struct serdes_map **serdes_map_array, u8 *count)
{
*serdes_map_array = serdes_topology_map;
*count = ARRAY_SIZE(serdes_topology_map);
return 0;
}
void board_pex_config(void)
{
#ifdef CONFIG_SPL_BUILD
uint k;
struct gpio_desc gpio = {};
if (!request_gpio_by_name(&gpio, "pca9698@22", 31, "fpga-program-gpio")) {
/* prepare FPGA reconfiguration */
dm_gpio_set_dir_flags(&gpio, GPIOD_IS_OUT);
dm_gpio_set_value(&gpio, 0);
/* give lunatic PCIe clock some time to stabilize */
mdelay(500);
/* start FPGA reconfiguration */
dm_gpio_set_dir_flags(&gpio, GPIOD_IS_IN);
}
/* wait for FPGA done */
if (!request_gpio_by_name(&gpio, "pca9698@22", 19, "fpga-done-gpio")) {
for (k = 0; k < 20; ++k) {
if (dm_gpio_get_value(&gpio)) {
printf("FPGA done after %u rounds\n", k);
break;
}
mdelay(100);
}
}
/* disable FPGA reset */
if (!request_gpio_by_name(&gpio, "gpio@18100", 6, "cpu-to-fpga-reset")) {
dm_gpio_set_dir_flags(&gpio, GPIOD_IS_OUT);
dm_gpio_set_value(&gpio, 1);
}
/* wait for FPGA ready */
if (!request_gpio_by_name(&gpio, "pca9698@22", 27, "fpga-ready-gpio")) {
for (k = 0; k < 2; ++k) {
if (!dm_gpio_get_value(&gpio))
break;
mdelay(100);
}
}
#endif
}
struct hws_topology_map *ddr3_get_topology_map(void)
{
return &ddr_topology_map;
}
int board_early_init_f(void)
{
#ifdef CONFIG_SPL_BUILD
/* Configure MPP */
writel(0x00111111, MVEBU_MPP_BASE + 0x00);
writel(0x40040000, MVEBU_MPP_BASE + 0x04);
writel(0x00466444, MVEBU_MPP_BASE + 0x08);
writel(0x00043300, MVEBU_MPP_BASE + 0x0c);
writel(0x44400000, MVEBU_MPP_BASE + 0x10);
writel(0x20000334, MVEBU_MPP_BASE + 0x14);
writel(0x40000000, MVEBU_MPP_BASE + 0x18);
writel(0x00004444, MVEBU_MPP_BASE + 0x1c);
/* Set GPP Out value */
writel(DB_GP_88F68XX_GPP_OUT_VAL_LOW, MVEBU_GPIO0_BASE + 0x00);
writel(DB_GP_88F68XX_GPP_OUT_VAL_MID, MVEBU_GPIO1_BASE + 0x00);
/* Set GPP Polarity */
writel(DB_GP_88F68XX_GPP_POL_LOW, MVEBU_GPIO0_BASE + 0x0c);
writel(DB_GP_88F68XX_GPP_POL_MID, MVEBU_GPIO1_BASE + 0x0c);
/* Set GPP Out Enable */
writel(DB_GP_88F68XX_GPP_OUT_ENA_LOW, MVEBU_GPIO0_BASE + 0x04);
writel(DB_GP_88F68XX_GPP_OUT_ENA_MID, MVEBU_GPIO1_BASE + 0x04);
#endif
return 0;
}
int board_init(void)
{
/* Address of boot parameters */
gd->bd->bi_boot_params = mvebu_sdram_bar(0) + 0x100;
return 0;
}
#ifndef CONFIG_SPL_BUILD
void init_host_phys(struct mii_dev *bus)
{
uint k;
for (k = 0; k < 2; ++k) {
struct phy_device *phydev;
phydev = phy_find_by_mask(bus, 1 << k,
PHY_INTERFACE_MODE_SGMII);
if (phydev)
phy_config(phydev);
}
}
int ccdc_eth_init(void)
{
uint k;
uint octo_phy_mask = 0;
int ret;
struct mii_dev *bus;
/* Init SoC's phys */
bus = miiphy_get_dev_by_name("ethernet@34000");
if (bus)
init_host_phys(bus);
bus = miiphy_get_dev_by_name("ethernet@70000");
if (bus)
init_host_phys(bus);
/* Init octo phys */
octo_phy_mask = calculate_octo_phy_mask();
printf("IHS PHYS: %08x", octo_phy_mask);
ret = init_octo_phys(octo_phy_mask);
if (ret)
return ret;
printf("\n");
if (!get_fpga()) {
puts("fpga was NULL\n");
return 1;
}
/* reset all FPGA-QSGMII instances */
for (k = 0; k < 80; ++k)
writel(1 << 31, get_fpga()->qsgmii_port_state[k]);
udelay(100);
for (k = 0; k < 80; ++k)
writel(0, get_fpga()->qsgmii_port_state[k]);
return 0;
}
#endif
int board_late_init(void)
{
#ifndef CONFIG_SPL_BUILD
hydra_initialize();
#endif
return 0;
}
int board_fix_fdt(void *rw_fdt_blob)
{
struct udevice *bus = NULL;
uint k;
char name[64];
int err;
err = uclass_get_device_by_name(UCLASS_I2C, "i2c@11000", &bus);
if (err) {
printf("Could not get I2C bus.\n");
return err;
}
for (k = 0x21; k <= 0x26; k++) {
snprintf(name, 64,
"/soc/internal-regs/i2c@11000/pca9698@%02x", k);
if (!dm_i2c_simple_probe(bus, k))
fdt_disable_by_ofname(rw_fdt_blob, name);
}
return 0;
}
int last_stage_init(void)
{
#ifndef CONFIG_SPL_BUILD
ccdc_eth_init();
#endif
if (tpm_init() || tpm_startup(TPM_ST_CLEAR) ||
tpm_continue_self_test()) {
return 1;
}
mdelay(37);
flush_keys();
load_and_run_keyprog();
return 0;
}