u-boot/drivers/mtd
Wolfgang Denk db39f24151 Merge branch 'master' of git://git.denx.de/u-boot-arm
* 'master' of git://git.denx.de/u-boot-arm:
  ARM926EJS: Fix cache.c to comply with checkpatch.pl
  ARM926EJS: Make asm routines volatile in cache ops
  MX35: mx35pdk: wrong board revision
  ARM1136: MX35: Make asm routines volatile in cache ops
  ARM: add u-boot.imx as target for i.MX SOCs
  M28: Pull out CONFIG_APBH_DMA so it's always enabled
  DMA: Split the APBH DMA init into block and channel init
  imx: Return gpio_set_value in gpio_direction_output
  imx: Use GPIO_TO_PORT macro in the gpio driver instead of (gpio >> 5)
  imx: Add GPIO_TO_PORT macro in the mxc_gpio driver
  imx: Remove unneeded/repititive definitions from imx headers
  i.MX28: Allow coexistence of PIO and DMA mode for SD/MMC
  MX31: mx31pdk: drop enable_caches from board file
  i.MX28: Fix initial stack pointer position
  mx35: mx35pdk: fix when cache functions are linked
  mx35: flea3: fix when cache functions are linked
  ARM: 926ejs: use debug() for misaligned addresses
  ARM1136: add cache flush and invalidate operations
  mx6qsabrelite: Fix the serial console port
  mx6qsabrelite: Add boot switch setting information into the README
  i.MX6: mx6qsabrelite: add cache commands if cache is enabled
  i.MX6: implement enable_caches()
  i.MX6: define CACHELINE_SIZE
  MX53: DDR: Fix ZQHWCTRL field TZQ_CS
  mx28evk: Add a README file
  mx28: Split the README into a common part and a m28 specific part
  tricorder: Load kernel from ubifs
  tricorder: Add UBIFS
  cm-t35: fix Ethernet reset timing
  hawkboard: Add CONFIG_SPL_LIBGENERIC_SUPPORT
  BeagleBoard: Remove userbutton command and use gpio command instead
  OMAP: Move omap1510inn to Unmaintained / Orphaned
2012-04-16 23:01:12 +02:00
..
nand DMA: Split the APBH DMA init into block and channel init 2012-04-16 14:53:59 +02:00
onenand onenand: Replace ONENAND_IS_MLC() with ONENAND_HAS_4KB() 2012-04-04 17:08:40 +02:00
spi sf: eeprom_m95xxx: set a sane default timeout 2012-02-12 15:18:28 -05:00
ubi UBI: init eba tables before wl when attaching a device 2011-10-12 11:36:05 +02:00
at45.c drivers/mtd: Move conditional compilation to Makefile 2008-08-13 01:40:42 +02:00
cfi_flash.c cfi: fix the incomplete erased status check in buffer write 2012-03-21 16:25:33 +01:00
cfi_mtd.c CFI: fix warning: variable ... set but not used 2011-10-09 23:24:49 +02:00
dataflash.c drivers/mtd/dataflash.c: Fix GCC 4.6 warning 2011-11-16 21:28:47 +01:00
ftsmc020.c ftsmc020: fix relocation 2011-05-12 23:43:27 +02:00
jedec_flash.c add STM29F400BB to table of supported legacy flashs 2012-02-09 09:45:53 +01:00
Makefile ftsmc020: move ftsmc020 static mem controller to driver/mtd 2011-04-27 19:38:10 +02:00
mtdconcat.c mtd: Add MTD concat support to concatenate multiple MTD NOR devices 2009-06-12 20:45:47 +02:00
mtdcore.c Followup fixes on the mtdparts spread patchset 2010-10-11 15:11:01 -05:00
mtdpart.c nand: remove dead code and suspend/resume 2010-10-11 15:10:35 -05:00
mw_eeprom.c Update i386 code (sc520_cdp) 2008-09-09 11:48:53 +02:00
spr_smi.c drivers/mtd/spr_smi.c: Fix build warning 2012-04-14 23:03:13 +02:00