u-boot/board/engicam/geam6ul
Simon Glass 382bee57f1 env: Rename setenv() to env_set()
We are now using an env_ prefix for environment functions. Rename setenv()
for consistency. Also add function comments in common.h.

Suggested-by: Wolfgang Denk <wd@denx.de>
Signed-off-by: Simon Glass <sjg@chromium.org>
2017-08-16 08:22:18 -04:00
..
geam6ul.c env: Rename setenv() to env_set() 2017-08-16 08:22:18 -04:00
Kconfig engicam: Generate single config file 2017-05-31 10:39:35 +02:00
MAINTAINERS i.MX6: engicam: Include dts files under MAINTAINERS 2017-03-17 09:27:08 +01:00
Makefile arm: imx6ul: Add Engicam GEAM6UL Starter Kit initial support 2016-12-16 17:16:10 +01:00
README arm: imx6ul: Add Engicam GEAM6UL Starter Kit initial support 2016-12-16 17:16:10 +01:00

How to use U-Boot on Engicam GEAM6UL Starter Kit:
-------------------------------------------------

- Configure U-Boot for Engicam GEAM6UL:

$ make mrproper
$ make imx6ul_geam_mmc_defconfig
$ make

This will generate the SPL image called SPL and the u-boot-dtb.img.

- Flash the SPL image into the micro SD card:

sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

- Flash the u-boot-dtb.img image into the micro SD card:

sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Jumper settings:

MMC Boot: JM3 Closed

- Connect the Serial cable between the Starter Kit and the PC for the console.
(J28 is the Linux Serial console connector)

- Insert the micro SD card in the board, power it up and U-Boot messages should
come up.