u-boot/arch/arm/cpu/armv8/fsl-layerscape/Makefile
Mingkai Hu f3a8e2b7d4 armv8/ls1043ardb: Add LS1043ARDB board support
LS1043ARDB Specification:
-------------------------
Memory subsystem:
 * 2GByte DDR4 SDRAM (32bit bus)
 * 128 Mbyte NOR flash single-chip memory
 * 512 Mbyte NAND flash
 * 16 Mbyte high-speed SPI flash
 * SD connector to interface with the SD memory card

Ethernet:
 * XFI 10G port
 * QSGMII with 4x 1G ports
 * Two RGMII ports

PCIe:
 * PCIe2 (Lanes C) to mini-PCIe slot
 * PCIe3 (Lanes D) to PCIe slot

USB 3.0: two super speed USB 3.0 type A ports

UART: supports two UARTs up to 115200 bps for console

Signed-off-by: Hou Zhiqiang <B48286@freescale.com>
Signed-off-by: Li Yang <leoli@freescale.com>
Signed-off-by: Mingkai Hu <Mingkai.Hu@freescale.com>
Signed-off-by: York Sun <yorksun@freescale.com>
Signed-off-by: Gong Qianyu <Qianyu.Gong@freescale.com>
2015-10-29 10:34:01 -07:00

30 lines
627 B
Makefile

#
# Copyright 2014-2015, Freescale Semiconductor
#
# SPDX-License-Identifier: GPL-2.0+
#
obj-y += cpu.o
obj-y += lowlevel.o
obj-y += soc.o
obj-$(CONFIG_MP) += mp.o
obj-$(CONFIG_OF_LIBFDT) += fdt.o
obj-$(CONFIG_SPL) += spl.o
ifneq ($(CONFIG_FSL_LSCH3),)
obj-y += fsl_lsch3_speed.o
obj-$(CONFIG_SYS_HAS_SERDES) += fsl_lsch3_serdes.o
else
ifneq ($(CONFIG_FSL_LSCH2),)
obj-y += fsl_lsch2_speed.o
obj-$(CONFIG_SYS_HAS_SERDES) += fsl_lsch2_serdes.o
endif
endif
ifneq ($(CONFIG_LS2085A),)
obj-$(CONFIG_SYS_HAS_SERDES) += ls2085a_serdes.o
else
ifneq ($(CONFIG_LS1043A),)
obj-$(CONFIG_SYS_HAS_SERDES) += ls1043a_serdes.o
endif
endif