u-boot/arch/arm/include/asm/arch-omap3/sys_proto.h
Paul Kocialkowski cfac375616 omap3: Definitions for SYS_BOOT-based fallback boot device selection
This introduces code to read the value of the SYS_BOOT pins on the OMAP3, as
well as the memory-preferred scheme for the interpretation of each value.

Signed-off-by: Paul Kocialkowski <contact@paulk.fr>
2015-07-27 15:02:07 -04:00

79 lines
1.8 KiB
C

/*
* (C) Copyright 2004-2008
* Texas Instruments, <www.ti.com>
* Richard Woodruff <r-woodruff2@ti.com>
*
* SPDX-License-Identifier: GPL-2.0+
*/
#ifndef _SYS_PROTO_H_
#define _SYS_PROTO_H_
#include <linux/mtd/omap_gpmc.h>
#include <asm/omap_common.h>
typedef struct {
u32 mtype;
char *board_string;
char *nand_string;
} omap3_sysinfo;
struct emu_hal_params {
u32 num_params;
u32 param1;
};
/* Board SDRC timing values */
struct board_sdrc_timings {
u32 sharing;
u32 mcfg;
u32 ctrla;
u32 ctrlb;
u32 rfr_ctrl;
u32 mr;
};
void prcm_init(void);
void per_clocks_enable(void);
void ehci_clocks_enable(void);
void memif_init(void);
void sdrc_init(void);
void do_sdrc_init(u32, u32);
void get_board_mem_timings(struct board_sdrc_timings *timings);
void identify_nand_chip(int *mfr, int *id);
void emif4_init(void);
void gpmc_init(void);
void enable_gpmc_cs_config(const u32 *gpmc_config, struct gpmc_cs *cs, u32 base,
u32 size);
void watchdog_init(void);
void set_muxconf_regs(void);
u32 get_cpu_family(void);
u32 get_cpu_rev(void);
u32 get_sku_id(void);
u32 is_gpmc_muxed(void);
u32 get_gpmc0_type(void);
u32 get_gpmc0_width(void);
u32 is_running_in_sdram(void);
u32 is_running_in_sram(void);
u32 is_running_in_flash(void);
u32 get_device_type(void);
void secureworld_exit(void);
void try_unlock_memory(void);
u32 get_boot_type(void);
void invalidate_dcache(u32);
u32 wait_on_value(u32, u32, void *, u32);
void cancel_out(u32 *num, u32 *den, u32 den_limit);
void sdelay(unsigned long);
void make_cs1_contiguous(void);
void omap_nand_switch_ecc(uint32_t, uint32_t);
void power_init_r(void);
void dieid_num_r(void);
void get_dieid(u32 *id);
void do_omap3_emu_romcode_call(u32 service_id, u32 parameters);
void omap3_set_aux_cr_secure(u32 acr);
u32 warm_reset(void);
void save_omap_boot_params(void);
#endif