u-boot/include/linux/mtd/fsl_upm.h
Wolfgang Grandegger 33846df28f Add wait flags to support board/chip specific delays
The NAND flash on the TQM8548_BE modules requires a short delay after
running the UPM pattern like the MPC8360ERDK board does. The TQM8548_BE
requires a further short delay after writing out a buffer. Normally the
R/B pin should be checked, but it's not connected on the TQM8548_BE.
The corresponding Linux FSL UPM driver uses similar delay points at the
same locations. To manage these extra delays in a more general way, I
introduced the "wait_flags" field allowing the board-specific driver to
specify various types of extra delay.

Signed-off-by: Wolfgang Grandegger <wg@grandegger.com>
Signed-off-by: Scott Wood <scottwood@freescale.com>
2009-03-23 15:53:40 -05:00

48 lines
1 KiB
C

/*
* FSL UPM NAND driver
*
* Copyright (C) 2007 MontaVista Software, Inc.
* Anton Vorontsov <avorontsov@ru.mvista.com>
*
* This program is free software; you can redistribute it and/or
* modify it under the terms of the GNU General Public License as
* published by the Free Software Foundation; either version 2 of
* the License, or (at your option) any later version.
*/
#ifndef __LINUX_MTD_NAND_FSL_UPM
#define __LINUX_MTD_NAND_FSL_UPM
#include <linux/mtd/nand.h>
#define FSL_UPM_WAIT_RUN_PATTERN 0x1
#define FSL_UPM_WAIT_WRITE_BYTE 0x2
#define FSL_UPM_WAIT_WRITE_BUFFER 0x4
struct fsl_upm {
void __iomem *mdr;
void __iomem *mxmr;
void __iomem *mar;
void __iomem *io_addr;
};
struct fsl_upm_nand {
struct fsl_upm upm;
int width;
int upm_cmd_offset;
int upm_addr_offset;
int upm_mar_chip_offset;
int wait_flags;
int (*dev_ready)(int chip_nr);
int chip_delay;
int chip_offset;
int chip_nr;
/* no need to fill */
int last_ctrl;
};
extern int fsl_upm_nand_init(struct nand_chip *chip, struct fsl_upm_nand *fun);
#endif