u-boot/board/phytec/pcl063
Yangbo Lu e37ac717d7 Convert to use fsl_esdhc_imx for i.MX platforms
Converted to use fsl_esdhc_imx for i.MX platforms.

Signed-off-by: Yangbo Lu <yangbo.lu@nxp.com>
Tested-by: Steffen Dirkwinkel <s.dirkwinkel@beckhoff.com>
Reviewed-by: Peng Fan <peng.fan@nxp.com>
Reviewed-by: Lukasz Majewski <lukma@denx.de>
Reviewed-by: Martyn Welch <martyn.welch@collabora.com>
Acked-by: Jason Liu <Jason.hui.liu@nxp.com>
2019-06-23 14:18:34 +08:00
..
Kconfig imx: Extend PCL063 support for phyCORE-i.MX6ULL SOM 2019-06-11 10:42:48 +02:00
MAINTAINERS imx: Extend PCL063 support for phyCORE-i.MX6ULL SOM 2019-06-11 10:42:48 +02:00
Makefile imx: Add PHYTEC phyBOARD-i.MX6UL-Segin 2019-01-28 12:47:27 +01:00
pcl063.c Convert to use fsl_esdhc_imx for i.MX platforms 2019-06-23 14:18:34 +08:00
README imx: Add PHYTEC phyBOARD-i.MX6UL-Segin 2019-01-28 12:47:27 +01:00
spl.c Convert to use fsl_esdhc_imx for i.MX platforms 2019-06-23 14:18:34 +08:00

How to use U-Boot on PHYTEC phyBOARD-i.MX6UL-Segin
--------------------------------------------------

- Configure and build U-Boot for phyCORE-i.MX6UL:

    $ make mrproper
    $ make phycore_pcl063_defconfig
    $ make

  This will generate SPL and u-boot-dtb.img images.

- The SPL and u-boot-dtb.img images need to be flashed into the micro SD card:

    $ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
    $ sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Jumper settings:

  JP1:   Open: Boot from NAND
       Closed: Boot from SD/MMC1

- Connect the Serial cable to UART0 and the PC for the console.

- Insert the micro SD card in the board and power it up.

- U-Boot messages should come up.