u-boot/include/configs/bcm_ep_board.h
Tom Rini a09fea1d28 env: Finish migration of common ENV options
- In ARMv8 NXP Layerscape platforms we also need to make use of
  CONFIG_SYS_RELOC_GD_ENV_ADDR now, do so.
- On ENV_IS_IN_REMOTE, CONFIG_ENV_OFFSET is never used, drop the define
  to 0.
- Add Kconfig entry for ENV_ADDR.
- Make ENV_ADDR / ENV_OFFSET depend on the env locations that use it.
- Add ENV_xxx_REDUND options that depend on their primary option and
  SYS_REDUNDAND_ENVIRONMENT
- On a number of PowerPC platforms, use SPL_ENV_ADDR not CONFIG_ENV_ADDR
  for the pre-main-U-Boot environment location.
- On ENV_IS_IN_SPI_FLASH, check not for CONFIG_ENV_ADDR being set but
  rather it being non-zero, as it will now be zero by default.
- Rework the env_offset absolute in env/embedded.o to not use
  CONFIG_ENV_OFFSET as it was the only use of ENV_OFFSET within
  ENV_IS_IN_FLASH.
- Migrate all platforms.

Cc: Wolfgang Denk <wd@denx.de>
Cc: Joe Hershberger <joe.hershberger@ni.com>
Cc: Patrick Delaunay <patrick.delaunay@st.com>
Cc: uboot-stm32@st-md-mailman.stormreply.com
Signed-off-by: Tom Rini <trini@konsulko.com>
Acked-by: Joe Hershberger <joe.hershberger@ni.com>
Reviewed-by: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>
2019-11-20 18:32:09 -05:00

54 lines
1.3 KiB
C

/* SPDX-License-Identifier: GPL-2.0+ */
/*
* Copyright 2014 Broadcom Corporation.
*/
#ifndef __BCM_EP_BOARD_H
#define __BCM_EP_BOARD_H
#include <asm/arch/configs.h>
#define CONFIG_SKIP_LOWLEVEL_INIT
/*
* Memory configuration
* (these must be defined elsewhere)
*/
#ifndef CONFIG_SYS_TEXT_BASE
#error CONFIG_SYS_TEXT_BASE must be defined!
#endif
#ifndef CONFIG_SYS_SDRAM_BASE
#error CONFIG_SYS_SDRAM_BASE must be defined!
#endif
#ifndef CONFIG_SYS_SDRAM_SIZE
#error CONFIG_SYS_SDRAM_SIZE must be defined!
#endif
#define CONFIG_SYS_MALLOC_LEN (4 * 1024 * 1024)
/* Some commands use this as the default load address */
#define CONFIG_SYS_LOAD_ADDR CONFIG_SYS_SDRAM_BASE
/*
* This is the initial SP which is used only briefly for relocating the u-boot
* image to the top of SDRAM. After relocation u-boot moves the stack to the
* proper place.
*/
#define CONFIG_SYS_INIT_SP_ADDR CONFIG_SYS_TEXT_BASE
/* allow to overwrite serial and ethaddr */
#define CONFIG_ENV_OVERWRITE
/* Serial Info */
#define CONFIG_SYS_NS16550_SERIAL
/* console configuration */
#define CONFIG_SYS_CBSIZE 1024 /* Console buffer size */
#define CONFIG_SYS_MAXARGS 64
#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE
/* version string, parser, etc */
/* Enable Time Command */
#endif /* __BCM_EP_BOARD_H */