mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-06 21:24:29 +00:00
344eb6d572
The ESM (Error Signaling Module) is used to route error signals within the K3 SoCs somewhat similar to interrupts. The handling for these is different though, and can be routed for hardware error handling, to be handled by safety processor or just as error interrupts handled by the main processor. The u-boot level ESM driver is just used to configure the ESM signals so that they get routed to proper destination. Signed-off-by: Tero Kristo <t-kristo@ti.com>
25 lines
862 B
Text
25 lines
862 B
Text
Texas Instruments K3 ESM Binding
|
|
======================
|
|
|
|
ESM (Error Signaling Module) is an IP block on TI K3 devices that allows
|
|
handling of safety events somewhat similar to what interrupt controller
|
|
would do. The safety signals have their separate paths within the SoC,
|
|
and they are handled by the ESM, which routes them to the proper
|
|
destination, which can be system reset, interrupt controller, etc. In
|
|
the simplest configuration the signals are just routed to reset the
|
|
SoC.
|
|
|
|
Required properties :
|
|
- compatible : "ti,j721e-esm"
|
|
- ti,esm-pins : integer array of esm events IDs to route to external event
|
|
pin which can be used to reset the SoC. The array can
|
|
have arbitrary amount of event IDs listed on it.
|
|
|
|
Example
|
|
=======
|
|
|
|
main_esm: esm@700000 {
|
|
compatible = "ti,j721e-esm";
|
|
reg = <0x0 0x700000 0x0 0x1000>;
|
|
ti,esm-pins = <344>, <345>;
|
|
};
|