mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-19 03:08:31 +00:00
5c0d38f655
i.CoreM6 Quad/Dual modules are system on module solutions manufactured by Engicam with following characteristics: CPU NXP i.MX6 DQ, 800MHz RAM 1GB, 32, 64 bit, DDR3-800/1066 NAND SLC,512MB Power supply Single 5V MAX LCD RES FULLHD and more info at http://www.engicam.com/en/products/embedded/som/sodimm/i-core-m6s-dl-d-q Cc: Peng Fan <peng.fan@nxp.com> Cc: Stefano Babic <sbabic@denx.de> Cc: Fabio Estevam <fabio.estevam@nxp.com> Cc: Matteo Lisi <matteo.lisi@engicam.com> Cc: Michael Trimarchi <michael@amarulasolutions.com> Signed-off-by: Jagan Teki <jagan@amarulasolutions.com>
38 lines
1,013 B
Text
38 lines
1,013 B
Text
How to use U-Boot on Engicam i.CoreM6 DualLite/Solo and Quad/Dual Starter Kit:
|
|
-----------------------------------------------------------------------------
|
|
|
|
- Configure U-Boot for Engicam i.CoreM6 QDL:
|
|
|
|
$ make mrproper
|
|
$ make icorem6qdl_mmc_defconfig
|
|
|
|
- Build for i.CoreM6 DualLite/Solo
|
|
|
|
$ make
|
|
|
|
- Build for i.CoreM6 Quad/Dual
|
|
|
|
$ make DEVICE_TREE=imx6q-icore
|
|
|
|
This will generate the SPL image called SPL and the u-boot-dtb.img.
|
|
|
|
- Flash the SPL image into the micro SD card:
|
|
|
|
sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
|
|
|
|
- Flash the u-boot-dtb.img image into the micro SD card:
|
|
|
|
sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync
|
|
|
|
- Jumper settings:
|
|
|
|
MMC Boot: JM3 Closed
|
|
|
|
- Connect the Serial cable between the Starter Kit and the PC for the console.
|
|
(J28 is the Linux Serial console connector)
|
|
|
|
- Insert the micro SD card in the board, power it up and U-Boot messages should
|
|
come up.
|
|
|
|
- Note: For loading Linux on Quad/Dual modules set the dtb as
|
|
icorem6qdl> setenv fdt_file imx6q-icore.dtb
|