u-boot/board/phytec/pcl063
Martyn Welch 0963060c99 imx: Add PHYTEC phyBOARD-i.MX6UL-Segin
Port for the PHYTEC phyBOARD-i.MX6UL-Segin single board computer. Based on
the PHYTEC phyCORE-i.MX6UL SOM (PCL063).

CPU:   Freescale i.MX6UL rev1.2 528 MHz (running at 396 MHz)
CPU:   Industrial temperature grade (-40C to 105C) at 44C
Reset cause: POR
Board: PHYTEC phyCORE-i.MX6UL
I2C:   ready
DRAM:  256 MiB
NAND:  512 MiB
MMC:   FSL_SDHC: 0
In:    serial
Out:   serial
Err:   serial
Net:   FEC0

Working:
 - Eth0
 - i2C
 - MMC/SD
 - NAND
 - UART (1 & 5)
 - USB (host & otg)

Signed-off-by: Martyn Welch <martyn.welch@collabora.com>
2019-01-28 12:47:27 +01:00
..
Kconfig imx: Add PHYTEC phyBOARD-i.MX6UL-Segin 2019-01-28 12:47:27 +01:00
MAINTAINERS imx: Add PHYTEC phyBOARD-i.MX6UL-Segin 2019-01-28 12:47:27 +01:00
Makefile imx: Add PHYTEC phyBOARD-i.MX6UL-Segin 2019-01-28 12:47:27 +01:00
pcl063.c imx: Add PHYTEC phyBOARD-i.MX6UL-Segin 2019-01-28 12:47:27 +01:00
README imx: Add PHYTEC phyBOARD-i.MX6UL-Segin 2019-01-28 12:47:27 +01:00
spl.c imx: Add PHYTEC phyBOARD-i.MX6UL-Segin 2019-01-28 12:47:27 +01:00

How to use U-Boot on PHYTEC phyBOARD-i.MX6UL-Segin
--------------------------------------------------

- Configure and build U-Boot for phyCORE-i.MX6UL:

    $ make mrproper
    $ make phycore_pcl063_defconfig
    $ make

  This will generate SPL and u-boot-dtb.img images.

- The SPL and u-boot-dtb.img images need to be flashed into the micro SD card:

    $ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
    $ sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Jumper settings:

  JP1:   Open: Boot from NAND
       Closed: Boot from SD/MMC1

- Connect the Serial cable to UART0 and the PC for the console.

- Insert the micro SD card in the board and power it up.

- U-Boot messages should come up.