u-boot/board/udoo
Fabio Estevam 7c4f0ff81e udoo: neo: Fix indentation
The standard way is to put ifdef/endif in the very first column.

Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
2017-01-02 17:55:58 +01:00
..
neo udoo: neo: Fix indentation 2017-01-02 17:55:58 +01:00
Kconfig mx6: remove SYS_SOC from board Kconfig 2015-09-13 10:37:29 +02:00
MAINTAINERS MAINTAINERS/mailmap: Update my email address 2016-01-11 11:22:43 -05:00
Makefile udoo: Switch to SPL support 2015-09-02 15:25:28 +02:00
README udoo: Add a README file 2016-10-06 09:40:34 +02:00
udoo.c treewide: replace #include <asm/errno.h> with <linux/errno.h> 2016-09-23 17:55:42 -04:00
udoo_spl.c treewide: replace #include <asm/errno.h> with <linux/errno.h> 2016-09-23 17:55:42 -04:00

How to use U-Boot on MX6Q/DL Udoo boards
----------------------------------------

- Build U-Boot for MX6Q/DL Udoo boards:

$ make mrproper
$ make udoo_defconfig
$ make

This will generate the SPL image called SPL and the u-boot.img.

- Flash the SPL image into the SD card:

sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

- Flash the u-boot.img image into the SD card:

sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Insert the SD card in the board, power it up and U-Boot messages should
come up.