u-boot/doc/device-tree-bindings/spi/spi-stm32-qspi.txt
Michael Kurz b1a8de7e07 ARM: DTS: stm32: add stm32f746-disco device tree files
This patch adds the DTS source files needed for stm32f746-disco board
The files are based on the stm32f429/469 files from current linux
kernel.

Source for "arch/arm/dts/armv7-m.dtsi": Linux: "arch/arm/boot/dts/armv7-m.dtsi"

Signed-off-by: Michael Kurz <michi.kurz@gmail.com>
Acked-by: Vikas MANOCHA <vikas.manocha@st.com>
2017-01-28 14:04:42 -05:00

39 lines
1.2 KiB
Text

STM32 QSPI controller device tree bindings
--------------------------------------------
Required properties:
- compatible : should be "st,stm32-qspi".
- reg : 1. Physical base address and size of SPI registers map.
2. Physical base address & size of mapped NOR Flash.
- spi-max-frequency : Max supported spi frequency.
- status : enable in requried dts.
Connected flash properties
--------------------------
- spi-max-frequency : Max supported spi frequency.
- spi-tx-bus-width : Bus width (number of lines) for writing (1-4)
- spi-rx-bus-width : Bus width (number of lines) for reading (1-4)
- memory-map : Address and size for memory-mapping the flash
Example:
qspi: quadspi@A0001000 {
compatible = "st,stm32-qspi";
#address-cells = <1>;
#size-cells = <0>;
reg = <0xA0001000 0x1000>, <0x90000000 0x10000000>;
reg-names = "QuadSPI", "QuadSPI-memory";
interrupts = <92>;
spi-max-frequency = <108000000>;
status = "okay";
qflash0: n25q128a {
#address-cells = <1>;
#size-cells = <1>;
compatible = "micron,n25q128a13", "spi-flash";
spi-max-frequency = <108000000>;
spi-tx-bus-width = <4>;
spi-rx-bus-width = <4>;
memory-map = <0x90000000 0x1000000>;
reg = <0>;
};
};