u-boot/board/toradex/apalis_t30/apalis_t30.c
Marcel Ziswiler 71cb3d7c78 apalis_t30: fix optional pcie port reset for reliable pcie operation
Allow optionally bringing up the Apalis type specific 4 lane PCIe port
as well as the PCIe switch as found on the Apalis Evaluation board. In
order to avoid violating the PCIe reset timing do this by overriding the
tegra_pcie_board_port_reset() function. Note however that both the
Apalis type specific 4 lane PCIe port as well as the regular Apalis PCIe
port are also left disabled in the device tree by default.

Signed-off-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
Acked-by: Stephen Warren <swarren@nvidia.com>
Signed-off-by: Tom Warren <twarren@nvidia.com>
2018-05-10 16:34:30 -07:00

166 lines
3.8 KiB
C

// SPDX-License-Identifier: GPL-2.0+
/*
* (C) Copyright 2014-2018
* Marcel Ziswiler <marcel@ziswiler.com>
*/
#include <common.h>
#include <asm/arch/gp_padctrl.h>
#include <asm/arch/pinmux.h>
#include <asm/arch-tegra/ap.h>
#include <asm/arch-tegra/tegra.h>
#include <asm/gpio.h>
#include <asm/io.h>
#include <dm.h>
#include <i2c.h>
#include <pci_tegra.h>
#include "../common/tdx-common.h"
#include "pinmux-config-apalis_t30.h"
DECLARE_GLOBAL_DATA_PTR;
#define PMU_I2C_ADDRESS 0x2D
#define MAX_I2C_RETRY 3
#ifdef CONFIG_APALIS_T30_PCIE_EVALBOARD_INIT
#define PEX_PERST_N TEGRA_GPIO(S, 7) /* Apalis GPIO7 */
#define RESET_MOCI_CTRL TEGRA_GPIO(I, 4)
static int pci_reset_status;
#endif /* CONFIG_APALIS_T30_PCIE_EVALBOARD_INIT */
int arch_misc_init(void)
{
if (readl(NV_PA_BASE_SRAM + NVBOOTINFOTABLE_BOOTTYPE) ==
NVBOOTTYPE_RECOVERY)
printf("USB recovery mode\n");
return 0;
}
int checkboard(void)
{
printf("Model: Toradex Apalis T30 %dGB\n",
(gd->ram_size == 0x40000000) ? 1 : 2);
return 0;
}
#if defined(CONFIG_OF_LIBFDT) && defined(CONFIG_OF_BOARD_SETUP)
int ft_board_setup(void *blob, bd_t *bd)
{
return ft_common_board_setup(blob, bd);
}
#endif
/*
* Routine: pinmux_init
* Description: Do individual peripheral pinmux configs
*/
void pinmux_init(void)
{
pinmux_config_pingrp_table(tegra3_pinmux_common,
ARRAY_SIZE(tegra3_pinmux_common));
pinmux_config_pingrp_table(unused_pins_lowpower,
ARRAY_SIZE(unused_pins_lowpower));
/* Initialize any non-default pad configs (APB_MISC_GP regs) */
pinmux_config_drvgrp_table(apalis_t30_padctrl,
ARRAY_SIZE(apalis_t30_padctrl));
}
#ifdef CONFIG_PCI_TEGRA
int tegra_pcie_board_init(void)
{
struct udevice *dev;
u8 addr, data[1];
int err;
err = i2c_get_chip_for_busnum(0, PMU_I2C_ADDRESS, 1, &dev);
if (err) {
debug("%s: Cannot find PMIC I2C chip\n", __func__);
return err;
}
/* TPS659110: VDD2_OP_REG = 1.05V */
data[0] = 0x27;
addr = 0x25;
err = dm_i2c_write(dev, addr, data, 1);
if (err) {
debug("failed to set VDD supply\n");
return err;
}
/* TPS659110: VDD2_REG 7.5 mV/us, ACTIVE */
data[0] = 0x0D;
addr = 0x24;
err = dm_i2c_write(dev, addr, data, 1);
if (err) {
debug("failed to enable VDD supply\n");
return err;
}
/* TPS659110: LDO6_REG = 1.1V, ACTIVE */
data[0] = 0x0D;
addr = 0x35;
err = dm_i2c_write(dev, addr, data, 1);
if (err) {
debug("failed to set AVDD supply\n");
return err;
}
#ifdef CONFIG_APALIS_T30_PCIE_EVALBOARD_INIT
gpio_request(PEX_PERST_N, "PEX_PERST_N");
gpio_request(RESET_MOCI_CTRL, "RESET_MOCI_CTRL");
#endif /* CONFIG_APALIS_T30_PCIE_EVALBOARD_INIT */
return 0;
}
void tegra_pcie_board_port_reset(struct tegra_pcie_port *port)
{
int index = tegra_pcie_port_index_of_port(port);
if (index == 2) { /* I210 Gigabit Ethernet Controller (On-module) */
tegra_pcie_port_reset(port);
}
#ifdef CONFIG_APALIS_T30_PCIE_EVALBOARD_INIT
/*
* Apalis PCIe aka port 1 and Apalis Type Specific 4 Lane PCIe aka port
* 0 share the same RESET_MOCI therefore only assert it once for both
* ports to avoid losing the previously brought up port again.
*/
else if ((index == 1) || (index == 0)) {
/* only do it once per init cycle */
if (pci_reset_status % 2 == 0) {
/*
* Reset PLX PEX 8605 PCIe Switch plus PCIe devices on
* Apalis Evaluation Board
*/
gpio_direction_output(PEX_PERST_N, 0);
gpio_direction_output(RESET_MOCI_CTRL, 0);
/*
* Must be asserted for 100 ms after power and clocks
* are stable
*/
mdelay(100);
gpio_set_value(PEX_PERST_N, 1);
/*
* Err_5: PEX_REFCLK_OUTpx/nx Clock Outputs is not
* Guaranteed Until 900 us After PEX_PERST# De-assertion
*/
mdelay(1);
gpio_set_value(RESET_MOCI_CTRL, 1);
}
pci_reset_status++;
}
#endif /* CONFIG_APALIS_T30_PCIE_EVALBOARD_INIT */
}
#endif /* CONFIG_PCI_TEGRA */