mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-10 23:24:38 +00:00
8976556a8a
LS(1021/1012/1028/1043/1046/1088/2088), LX2160, LX2162 platforms are enabled with JR driver model. removed sec_init() call from board files. sec is initialized based on job ring information processed from device tree. Signed-off-by: Gaurav Jain <gaurav.jain@nxp.com> Reviewed-by: Priyanka Jain <priyanka.jain@nxp.com> Reviewed-by: Michael Walle <michael@walle.cc> |
||
|---|---|---|
| .. | ||
| Kconfig | ||
| ls102xa_pbi.cfg | ||
| ls102xa_rcw_sd.cfg | ||
| ls1021aiot.c | ||
| MAINTAINERS | ||
| Makefile | ||
| psci.S | ||
| README | ||
Overview -------- The LS1021A-IOT is a Freescale reference board that hosts the LS1021A SoC. LS1021AIOT board Overview ------------------------- - DDR Controller - Supports 1GB un-buffered DDR3L SDRAM discrete devices(32-bit bus) with 4 bit ECC - DDR power supplies 1.35V to all devices with automatic tracking of VTT - Soldered DDR chip - Supprot one fixed speed - Ethernet - Two on-board SGMII 10/100/1G ethernet ports - One Gbit Etherent RGMII interface to 4-ports switch with 4x 10/100/1000 RJ145 ports - CPLD - 8-bit registers in CPLD for system configuration - connected to IFC_AD[0:7] - Power Supplies - 12V@5A DC - SDHC - SDHC port connects directly to a full 8-bit SD/MMC slot - Support for SDIO devices - USB - Two on-board USB 3.0 - One on-board USB k22 - PCIe - Two MiniPCIe Solts - SATA - Support SATA Connector - AUDIO - AUDIO in and out - I/O Expansion - Arduino Shield Connector - Port0 - CAN/GPIO/Flextimer - Port1 - GPIO/CPLD Expansion - Port2 - SPI/I2C/UART Memory map ----------- The addresses in brackets are physical addresses. Start Address End Address Description Size 0x00_0100_0000 0x00_0FFF_FFFF CCSRBAR 240MB 0x00_4000_0000 0x00_43FF_FFFF QSPI(Chip select 0) 64MB 0x00_4400_0000 0x00_47FF_FFFF QSPI(Chip select 1) 64MB 0x00_6000_0000 0x00_6000_FFFF CPLD 64K 0x00_8000_0000 0x00_BFFF_FFFF DDR 1GB Boot description ----------------- LS1021A-IOT support two ways of boot: Qspi boot and SD boot The board doesn't support boot from another source without changing any switch/jumper.