u-boot/arch/arm/mach-socfpga/misc.c
Masahiro Yamada 05a217212b ARM: socfpga: move SoC sources to mach-socfpga
Our recent trend is to collect SoC files into arch/arm/mach-(SOC).

Signed-off-by: Masahiro Yamada <yamada.masahiro@socionext.com>
2015-05-07 05:21:12 +02:00

289 lines
7 KiB
C

/*
* Copyright (C) 2012 Altera Corporation <www.altera.com>
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <asm/io.h>
#include <altera.h>
#include <miiphy.h>
#include <netdev.h>
#include <watchdog.h>
#include <asm/arch/reset_manager.h>
#include <asm/arch/system_manager.h>
#include <asm/arch/dwmmc.h>
#include <asm/arch/nic301.h>
#include <asm/arch/scu.h>
#include <asm/pl310.h>
DECLARE_GLOBAL_DATA_PTR;
static struct pl310_regs *const pl310 =
(struct pl310_regs *)CONFIG_SYS_PL310_BASE;
static struct socfpga_system_manager *sysmgr_regs =
(struct socfpga_system_manager *)SOCFPGA_SYSMGR_ADDRESS;
static struct socfpga_reset_manager *reset_manager_base =
(struct socfpga_reset_manager *)SOCFPGA_RSTMGR_ADDRESS;
static struct nic301_registers *nic301_regs =
(struct nic301_registers *)SOCFPGA_L3REGS_ADDRESS;
static struct scu_registers *scu_regs =
(struct scu_registers *)SOCFPGA_MPUSCU_ADDRESS;
int dram_init(void)
{
gd->ram_size = get_ram_size((long *)PHYS_SDRAM_1, PHYS_SDRAM_1_SIZE);
return 0;
}
void enable_caches(void)
{
#ifndef CONFIG_SYS_ICACHE_OFF
icache_enable();
#endif
#ifndef CONFIG_SYS_DCACHE_OFF
dcache_enable();
#endif
}
/*
* DesignWare Ethernet initialization
*/
#ifdef CONFIG_ETH_DESIGNWARE
int cpu_eth_init(bd_t *bis)
{
#if CONFIG_EMAC_BASE == SOCFPGA_EMAC0_ADDRESS
const int physhift = SYSMGR_EMACGRP_CTRL_PHYSEL0_LSB;
#elif CONFIG_EMAC_BASE == SOCFPGA_EMAC1_ADDRESS
const int physhift = SYSMGR_EMACGRP_CTRL_PHYSEL1_LSB;
#else
#error "Incorrect CONFIG_EMAC_BASE value!"
#endif
/* Initialize EMAC. This needs to be done at least once per boot. */
/*
* Putting the EMAC controller to reset when configuring the PHY
* interface select at System Manager
*/
socfpga_emac_reset(1);
/* Clearing emac0 PHY interface select to 0 */
clrbits_le32(&sysmgr_regs->emacgrp_ctrl,
SYSMGR_EMACGRP_CTRL_PHYSEL_MASK << physhift);
/* configure to PHY interface select choosed */
setbits_le32(&sysmgr_regs->emacgrp_ctrl,
SYSMGR_EMACGRP_CTRL_PHYSEL_ENUM_RGMII << physhift);
/* Release the EMAC controller from reset */
socfpga_emac_reset(0);
/* initialize and register the emac */
return designware_initialize(CONFIG_EMAC_BASE,
CONFIG_PHY_INTERFACE_MODE);
}
#endif
#ifdef CONFIG_DWMMC
/*
* Initializes MMC controllers.
* to override, implement board_mmc_init()
*/
int cpu_mmc_init(bd_t *bis)
{
return socfpga_dwmmc_init(SOCFPGA_SDMMC_ADDRESS,
CONFIG_HPS_SDMMC_BUSWIDTH, 0);
}
#endif
#if defined(CONFIG_DISPLAY_CPUINFO)
/*
* Print CPU information
*/
int print_cpuinfo(void)
{
puts("CPU: Altera SoCFPGA Platform\n");
return 0;
}
#endif
#if defined(CONFIG_SYS_CONSOLE_IS_IN_ENV) && \
defined(CONFIG_SYS_CONSOLE_OVERWRITE_ROUTINE)
int overwrite_console(void)
{
return 0;
}
#endif
#ifdef CONFIG_FPGA
/*
* FPGA programming support for SoC FPGA Cyclone V
*/
static Altera_desc altera_fpga[] = {
{
/* Family */
Altera_SoCFPGA,
/* Interface type */
fast_passive_parallel,
/* No limitation as additional data will be ignored */
-1,
/* No device function table */
NULL,
/* Base interface address specified in driver */
NULL,
/* No cookie implementation */
0
},
};
/* add device descriptor to FPGA device table */
static void socfpga_fpga_add(void)
{
int i;
fpga_init();
for (i = 0; i < ARRAY_SIZE(altera_fpga); i++)
fpga_add(fpga_altera, &altera_fpga[i]);
}
#else
static inline void socfpga_fpga_add(void) {}
#endif
int arch_cpu_init(void)
{
#ifdef CONFIG_HW_WATCHDOG
/*
* In case the watchdog is enabled, make sure to (re-)configure it
* so that the defined timeout is valid. Otherwise the SPL (Perloader)
* timeout value is still active which might too short for Linux
* booting.
*/
hw_watchdog_init();
#else
/*
* If the HW watchdog is NOT enabled, make sure it is not running,
* for example because it was enabled in the preloader. This might
* trigger a watchdog-triggered reboot of Linux kernel later.
*/
socfpga_watchdog_reset();
#endif
return 0;
}
/*
* Convert all NIC-301 AMBA slaves from secure to non-secure
*/
static void socfpga_nic301_slave_ns(void)
{
writel(0x1, &nic301_regs->lwhps2fpgaregs);
writel(0x1, &nic301_regs->hps2fpgaregs);
writel(0x1, &nic301_regs->acp);
writel(0x1, &nic301_regs->rom);
writel(0x1, &nic301_regs->ocram);
writel(0x1, &nic301_regs->sdrdata);
}
static uint32_t iswgrp_handoff[8];
int arch_early_init_r(void)
{
int i;
for (i = 0; i < 8; i++) /* Cache initial SW setting regs */
iswgrp_handoff[i] = readl(&sysmgr_regs->iswgrp_handoff[i]);
socfpga_bridges_reset(1);
socfpga_nic301_slave_ns();
/*
* Private components security:
* U-Boot : configure private timer, global timer and cpu component
* access as non secure for kernel stage (as required by Linux)
*/
setbits_le32(&scu_regs->sacr, 0xfff);
/* Configure the L2 controller to make SDRAM start at 0 */
#ifdef CONFIG_SOCFPGA_VIRTUAL_TARGET
writel(0x2, &nic301_regs->remap);
#else
writel(0x1, &nic301_regs->remap); /* remap.mpuzero */
writel(0x1, &pl310->pl310_addr_filter_start);
#endif
/* Add device descriptor to FPGA device table */
socfpga_fpga_add();
#ifdef CONFIG_DESIGNWARE_SPI
/* Get Designware SPI controller out of reset */
socfpga_spim_enable();
#endif
return 0;
}
static void socfpga_sdram_apply_static_cfg(void)
{
const uint32_t staticcfg = SOCFPGA_SDR_ADDRESS + 0x505c;
const uint32_t applymask = 0x8;
uint32_t val = readl(staticcfg) | applymask;
/*
* SDRAM staticcfg register specific:
* When applying the register setting, the CPU must not access
* SDRAM. Luckily for us, we can abuse i-cache here to help us
* circumvent the SDRAM access issue. The idea is to make sure
* that the code is in one full i-cache line by branching past
* it and back. Once it is in the i-cache, we execute the core
* of the code and apply the register settings.
*
* The code below uses 7 instructions, while the Cortex-A9 has
* 32-byte cachelines, thus the limit is 8 instructions total.
*/
asm volatile(
".align 5 \n"
" b 2f \n"
"1: str %0, [%1] \n"
" dsb \n"
" isb \n"
" b 3f \n"
"2: b 1b \n"
"3: nop \n"
: : "r"(val), "r"(staticcfg) : "memory", "cc");
}
int do_bridge(cmd_tbl_t *cmdtp, int flag, int argc, char * const argv[])
{
if (argc != 2)
return CMD_RET_USAGE;
argv++;
switch (*argv[0]) {
case 'e': /* Enable */
writel(iswgrp_handoff[2], &sysmgr_regs->fpgaintfgrp_module);
socfpga_sdram_apply_static_cfg();
writel(iswgrp_handoff[3], SOCFPGA_SDR_ADDRESS + 0x5080);
writel(iswgrp_handoff[0], &reset_manager_base->brg_mod_reset);
writel(iswgrp_handoff[1], &nic301_regs->remap);
break;
case 'd': /* Disable */
writel(0, &sysmgr_regs->fpgaintfgrp_module);
writel(0, SOCFPGA_SDR_ADDRESS + 0x5080);
socfpga_sdram_apply_static_cfg();
writel(0, &reset_manager_base->brg_mod_reset);
writel(1, &nic301_regs->remap);
break;
default:
return CMD_RET_USAGE;
}
return 0;
}
U_BOOT_CMD(
bridge, 2, 1, do_bridge,
"SoCFPGA HPS FPGA bridge control",
"enable - Enable HPS-to-FPGA, FPGA-to-HPS, LWHPS-to-FPGA bridges\n"
"bridge disable - Enable HPS-to-FPGA, FPGA-to-HPS, LWHPS-to-FPGA bridges\n"
""
);