mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-05 12:45:42 +00:00
ce87a88b4d
The existing common code for Engicam boards uses i.MX6, so attach that into i.MX6 Engicam boards so-that adding new SoC variants of Engicam boards become meaningful. Add support for it. Cc: Stefano Babic <sbabic@denx.de> Signed-off-by: Jagan Teki <jagan@amarulasolutions.com> Reviewed-by: Kever Yang<kever.yang@rock-chips.com> |
||
---|---|---|
.. | ||
imx6q.c | ||
Kconfig | ||
MAINTAINERS | ||
Makefile | ||
README |
Hsow to use U-Boot on Engicam i.CoreM6 (RQS) Solo/DualLite/Quad/Dual Starter Kit: -------------------------------------------------------------------------------- $ make mrproper - Configure U-Boot for Engicam i.CoreM6 Quad/Duali/Solo/DualLite: $ make imx6qdl_icore_mmc_defconfig - Configure U-Boot for Engicam i.CoreM6 RQS Quad/Duali/Solo/DualLite: $ make imx6qdl_icore_rqs_defconfig - Build U-Boot $ make This will generate the SPL image called SPL and the u-boot-dtb.img. - Flash the SPL image into the micro SD card: sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync - Flash the u-boot-dtb.img image into the micro SD card: sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync - Jumper settings: MMC Boot: JM3 Closed - Connect the Serial cable between the Starter Kit and the PC for the console. (J28 is the Linux Serial console connector) - Insert the micro SD card in the board, power it up and U-Boot messages should come up.