u-boot/board/mscc/serval/serval.c
Horatiu Vultur d2691b4af2 board: mscc: serval: Update MSCC Serval boards
In Serval SoC family there are 2 different pcb, both of them have the same
phy, but with different version. Therefore implement board_phy_config
and set all the phys in the same way.

Signed-off-by: Horatiu Vultur <horatiu.vultur@microchip.com>
2019-05-03 16:42:23 +02:00

86 lines
1.6 KiB
C

// SPDX-License-Identifier: (GPL-2.0+ OR MIT)
/*
* Copyright (c) 2018 Microsemi Corporation
*/
#include <common.h>
#include <asm/io.h>
#include <led.h>
#include <miiphy.h>
enum {
BOARD_TYPE_PCB106 = 0xAABBCD00,
BOARD_TYPE_PCB105,
};
int board_early_init_r(void)
{
/* Prepare SPI controller to be used in master mode */
writel(0, BASE_CFG + ICPU_SW_MODE);
/* Address of boot parameters */
gd->bd->bi_boot_params = CONFIG_SYS_SDRAM_BASE;
/* LED setup */
if (IS_ENABLED(CONFIG_LED))
led_default_state();
return 0;
}
int board_phy_config(struct phy_device *phydev)
{
phy_write(phydev, 0, 31, 0x10);
phy_write(phydev, 0, 18, 0x80F0);
while (phy_read(phydev, 0, 18) & 0x8000)
;
phy_write(phydev, 0, 14, 0x800);
phy_write(phydev, 0, 31, 0);
return 0;
}
static void do_board_detect(void)
{
u16 gpio_in_reg;
/* Set MDIO and MDC */
mscc_gpio_set_alternate(9, 2);
mscc_gpio_set_alternate(10, 2);
/* Set GPIO page */
mscc_phy_wr(1, 16, 31, 0x10);
if (!mscc_phy_rd(1, 16, 15, &gpio_in_reg)) {
if (gpio_in_reg & 0x200)
gd->board_type = BOARD_TYPE_PCB106;
else
gd->board_type = BOARD_TYPE_PCB105;
} else {
gd->board_type = BOARD_TYPE_PCB105;
}
mscc_phy_wr(1, 16, 31, 0x0);
}
#if defined(CONFIG_MULTI_DTB_FIT)
int board_fit_config_name_match(const char *name)
{
if (gd->board_type == BOARD_TYPE_PCB106 &&
strcmp(name, "serval_pcb106") == 0)
return 0;
if (gd->board_type == BOARD_TYPE_PCB105 &&
strcmp(name, "serval_pcb105") == 0)
return 0;
return -1;
}
#endif
#if defined(CONFIG_DTB_RESELECT)
int embedded_dtb_select(void)
{
do_board_detect();
fdtdec_setup();
return 0;
}
#endif