mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-19 11:18:28 +00:00
bdcf3a88cc
add phy-reset-gpios to reset phy Add board_phy_config to configure phy Enable DM_ETH Signed-off-by: Peng Fan <peng.fan@nxp.com> |
||
---|---|---|
.. | ||
imx8mm_evk.c | ||
Kconfig | ||
lpddr4_timing.c | ||
MAINTAINERS | ||
Makefile | ||
README | ||
spl.c |
U-Boot for the NXP i.MX8MM EVK board Quick Start =========== - Build the ARM Trusted firmware binary - Get ddr fimware - Build U-Boot - Boot Get and Build the ARM Trusted firmware ====================================== Note: srctree is U-Boot source directory Get ATF from: https://source.codeaurora.org/external/imx/imx-atf branch: imx_4.19.35_1.0.0 $ make PLAT=imx8mm bl31 $ cp build/imx8mm/release/bl31.bin $(srctree) Get the ddr and hdmi firmware ============================= $ wget https://www.nxp.com/lgfiles/NMG/MAD/YOCTO/firmware-imx-8.0.bin $ chmod +x firmware-imx-8.0.bin $ ./firmware-imx-8.0 $ cp firmware-imx-7.9/firmware/ddr/synopsys/lpddr4*.bin $(srctree) Build U-Boot ============ $ export CROSS_COMPILE=aarch64-poky-linux- $ make imx8mm_evk_defconfig $ export ATF_LOAD_ADDR=0x920000 $ make flash.bin Burn the flash.bin to MicroSD card offset 33KB $sudo dd if=flash.bin of=/dev/sd[x] bs=1024 seek=33 Boot ==== Set Boot switch to SD boot