u-boot/board/atmel/atngw100mkii/atngw100mkii.c
Andreas Bießmann 186678600a avr32: convert to dram_init()
Signed-off-by: Andreas Bießmann <andreas.devel@googlemail.com>
Reviewed-by: Simon Glass <sjg@chromium.org>
2015-02-17 22:52:41 +01:00

125 lines
3 KiB
C

/*
* Copyright (C) 2010 Atmel Corporation
*
* Copyright (C) 2012 Andreas Bießmann <andreas.devel@googlemail.com>
*
* SPDX-License-Identifier: GPL-2.0+
*/
#include <common.h>
#include <spi.h>
#include <netdev.h>
#include <asm/io.h>
#include <asm/sdram.h>
#include <asm/arch/clk.h>
#include <asm/arch/gpio.h>
#include <asm/arch/hmatrix.h>
#include <asm/arch/mmu.h>
#include <asm/arch/portmux.h>
DECLARE_GLOBAL_DATA_PTR;
struct mmu_vm_range mmu_vmr_table[CONFIG_SYS_NR_VM_REGIONS] = {
{
/* Atmel AT49BV640D 8 MiB x16 NOR flash on NCS0 */
.virt_pgno = CONFIG_SYS_FLASH_BASE >> MMU_PAGE_SHIFT,
.nr_pages = CONFIG_SYS_FLASH_SIZE >> MMU_PAGE_SHIFT,
.phys = (CONFIG_SYS_FLASH_BASE >> MMU_PAGE_SHIFT)
| MMU_VMR_CACHE_NONE,
}, {
/* Micron MT29F2G16AAD 256 MiB x16 NAND flash on NCS3 */
.virt_pgno = EBI_SRAM_CS3_BASE >> MMU_PAGE_SHIFT,
.nr_pages = EBI_SRAM_CS3_SIZE >> MMU_PAGE_SHIFT,
.phys = (EBI_SRAM_CS3_BASE >> MMU_PAGE_SHIFT)
| MMU_VMR_CACHE_NONE,
}, {
/* 2x16-bit ISSI IS42S16320B 64 MiB SDRAM (128 MiB total) */
.virt_pgno = CONFIG_SYS_SDRAM_BASE >> MMU_PAGE_SHIFT,
.nr_pages = EBI_SDRAM_SIZE >> MMU_PAGE_SHIFT,
.phys = (CONFIG_SYS_SDRAM_BASE >> MMU_PAGE_SHIFT)
| MMU_VMR_CACHE_WRBACK,
},
};
static const struct sdram_config sdram_config = {
.data_bits = SDRAM_DATA_32BIT,
.row_bits = 13,
.col_bits = 10,
.bank_bits = 2,
.cas = 3,
.twr = 2,
.trc = 7,
.trp = 2,
.trcd = 2,
.tras = 5,
.txsr = 6,
/* 7.81 us */
.refresh_period = (781 * (SDRAMC_BUS_HZ / 1000)) / 100000,
};
int board_early_init_f(void)
{
/* Enable SDRAM in the EBI mux */
hmatrix_slave_write(EBI, SFR, HMATRIX_BIT(EBI_SDRAM_ENABLE)
| HMATRIX_BIT(EBI_NAND_ENABLE));
portmux_enable_ebi(32, 23, PORTMUX_EBI_NAND,
PORTMUX_DRIVE_HIGH);
portmux_select_gpio(PORTMUX_PORT_E, 1 << 23,
PORTMUX_DIR_OUTPUT | PORTMUX_INIT_HIGH
| PORTMUX_DRIVE_MIN);
sdram_init(uncached(EBI_SDRAM_BASE), &sdram_config);
portmux_enable_usart1(PORTMUX_DRIVE_MIN);
#if defined(CONFIG_MACB)
portmux_enable_macb0(PORTMUX_MACB_MII, PORTMUX_DRIVE_HIGH);
portmux_enable_macb1(PORTMUX_MACB_MII, PORTMUX_DRIVE_HIGH);
#endif
#if defined(CONFIG_MMC)
portmux_enable_mmci(0, PORTMUX_MMCI_4BIT, PORTMUX_DRIVE_LOW);
#endif
#if defined(CONFIG_ATMEL_SPI)
portmux_enable_spi0(1 << 0, PORTMUX_DRIVE_LOW);
#endif
return 0;
}
int board_early_init_r(void)
{
gd->bd->bi_phy_id[0] = 0x01;
gd->bd->bi_phy_id[1] = 0x03;
return 0;
}
#ifdef CONFIG_CMD_NET
int board_eth_init(bd_t *bi)
{
macb_eth_initialize(0, (void *)ATMEL_BASE_MACB0, bi->bi_phy_id[0]);
macb_eth_initialize(1, (void *)ATMEL_BASE_MACB1, bi->bi_phy_id[1]);
return 0;
}
#endif
/* SPI chip select control */
#ifdef CONFIG_ATMEL_SPI
#define ATNGW100_DATAFLASH_CS_PIN GPIO_PIN_PA(3)
int spi_cs_is_valid(unsigned int bus, unsigned int cs)
{
return bus == 0 && cs == 0;
}
void spi_cs_activate(struct spi_slave *slave)
{
gpio_set_value(ATNGW100_DATAFLASH_CS_PIN, 0);
}
void spi_cs_deactivate(struct spi_slave *slave)
{
gpio_set_value(ATNGW100_DATAFLASH_CS_PIN, 1);
}
#endif /* CONFIG_ATMEL_SPI */