u-boot/configs/omapl138_lcdk_defconfig
Anna, Suman 7c0c6be52c configs: davinci: omapl138_lcdk: add random eth address support
Any TFTP or DHCP boot on the Davinci OMAP-L138 LCDK board requires
that the 'ethaddr' variable be defined. There are no e-fuses to store
the ethernet mac address for this platform, and neither is a MAC
address reserved in any format. So enable random MAC address support
so that networking boot can be supported.

Signed-off-by: Suman Anna <s-anna@ti.com>
Reviewed-by: Tom Rini <trini@konsulko.com>
Reviewed-by: Lokesh Vutla <lokeshvutla@ti.com>
2017-06-05 11:02:23 -04:00

35 lines
938 B
Text

CONFIG_ARM=y
CONFIG_ARCH_DAVINCI=y
CONFIG_TARGET_OMAPL138_LCDK=y
CONFIG_TI_COMMON_CMD_OPTIONS=y
CONFIG_SPL_LIBCOMMON_SUPPORT=y
CONFIG_SPL_LIBGENERIC_SUPPORT=y
CONFIG_SPL_MMC_SUPPORT=y
CONFIG_SPL_SERIAL_SUPPORT=y
CONFIG_SPL_NAND_SUPPORT=y
CONFIG_BOOTDELAY=3
CONFIG_VERSION_VARIABLE=y
# CONFIG_DISPLAY_CPUINFO is not set
# CONFIG_DISPLAY_BOARDINFO is not set
CONFIG_BOARD_EARLY_INIT_F=y
CONFIG_SPL=y
CONFIG_SPL_BOARD_INIT=y
CONFIG_SYS_MMCSD_RAW_MODE_U_BOOT_SECTOR=0xb5
CONFIG_HUSH_PARSER=y
# CONFIG_CMD_IMLS is not set
CONFIG_CRC32_VERIFY=y
# CONFIG_CMD_EEPROM is not set
# CONFIG_CMD_FLASH is not set
# CONFIG_CMD_GPIO is not set
# CONFIG_CMD_SETEXPR is not set
CONFIG_CMD_DIAG=y
CONFIG_CMD_UBI=y
CONFIG_NET_RANDOM_ETHADDR=y
CONFIG_SYS_NAND_U_BOOT_LOCATIONS=y
CONFIG_SYS_NAND_U_BOOT_OFFS=0x28000
CONFIG_SPI_FLASH=y
CONFIG_SPI_FLASH_STMICRO=y
CONFIG_SPI_FLASH_WINBOND=y
CONFIG_SYS_NS16550=y
# CONFIG_FAT_WRITE is not set
CONFIG_OF_LIBFDT=y