u-boot/board/solidrun/mx6cuboxi
Fabio Estevam ae40e82eef mx6cuboxi: Avoid calling setup_display() from SPL code
There is no need call setup_display() from SPL code, so move it to
board_init(), which executes only in U-Boot proper.

Reported-by: Stefano Babic <sbabic@denx.de>
Signed-off-by: Fabio Estevam <fabio.estevam@nxp.com>
Reviewed-by: Stefano Babic <sbabic@denx.de>
2017-10-12 17:30:32 +02:00
..
Kconfig mx6: remove SYS_SOC from board Kconfig 2015-09-13 10:37:29 +02:00
MAINTAINERS MAINTAINERS/mailmap: Update my email address 2016-01-11 11:22:43 -05:00
Makefile mx6: Add initial SPL support for HummingBoard-i2eX 2015-04-22 14:39:06 +02:00
mx6cuboxi.c mx6cuboxi: Avoid calling setup_display() from SPL code 2017-10-12 17:30:32 +02:00
README Use correct spelling of "U-Boot" 2016-02-06 12:00:59 +01:00

How to use U-Boot on Solid-run mx6 Hummingboard and Cubox-i
-----------------------------------------------------------

- Build U-Boot for Hummingboard/Cubox-i:

$ make mrproper
$ make mx6cuboxi_defconfig
$ make

This will generate the SPL image called SPL and the u-boot.img.

- Flash the SPL image into the SD card:

sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

- Flash the u-boot.img image into the SD card:

sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Insert the SD card in the board, power it up and U-Boot messages should
come up.