u-boot/doc/device-tree-bindings/mtd/spi/spi-flash.txt
Jagan Teki 6645fd2c18 sf: Rename sf_params.c to spi_flash_ids.c
Now the flash params table as renamed to spi_flash_ids structure,
so rename the sf_params.c to spi_flash_ids.c and remove the legacy.

Cc: Bin Meng <bmeng.cn@gmail.com>
Cc: York Sun <york.sun@nxp.com>
Cc: Vignesh R <vigneshr@ti.com>
Cc: Mugunthan V N <mugunthanvnm@ti.com>
Cc: Michal Simek <michal.simek@xilinx.com>
Signed-off-by: Jagan Teki <jagan@openedev.com>
Reviewed-by: Jagan Teki <jagan@openedev.com>
Tested-by: Jagan Teki <jagan@openedev.com>
Reviewed-by: Siva Durga Prasad Paladugu <sivadur@xilinx.com>
2016-11-18 13:04:54 +05:30

25 lines
890 B
Text

* MTD SPI driver for serial flash chips
Required properties:
- #address-cells, #size-cells : Must be present if the device has sub-nodes
representing partitions.
- compatible : Should be the manufacturer and the name of the chip. Bear in
mind that the DT binding is not U-Boot-only, but in case of
U-Boot, see spi_flash_params_table table in
drivers/mtd/spi/spi_flash_ids.c for the list of supported chips.
- reg : Chip-Select number
- spi-max-frequency : Maximum frequency of the SPI bus the chip can operate at
Optional properties:
- memory-map : Address and size of the flash, if memory mapped. This may
apply to Intel chipsets, which tend to memory-map flash.
Example:
flash: m25p80@0 {
#address-cells = <1>;
#size-cells = <1>;
compatible = "spansion,m25p80";
reg = <0>;
spi-max-frequency = <40000000>;
};