mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-12-12 06:12:58 +00:00
a09fea1d28
- In ARMv8 NXP Layerscape platforms we also need to make use of CONFIG_SYS_RELOC_GD_ENV_ADDR now, do so. - On ENV_IS_IN_REMOTE, CONFIG_ENV_OFFSET is never used, drop the define to 0. - Add Kconfig entry for ENV_ADDR. - Make ENV_ADDR / ENV_OFFSET depend on the env locations that use it. - Add ENV_xxx_REDUND options that depend on their primary option and SYS_REDUNDAND_ENVIRONMENT - On a number of PowerPC platforms, use SPL_ENV_ADDR not CONFIG_ENV_ADDR for the pre-main-U-Boot environment location. - On ENV_IS_IN_SPI_FLASH, check not for CONFIG_ENV_ADDR being set but rather it being non-zero, as it will now be zero by default. - Rework the env_offset absolute in env/embedded.o to not use CONFIG_ENV_OFFSET as it was the only use of ENV_OFFSET within ENV_IS_IN_FLASH. - Migrate all platforms. Cc: Wolfgang Denk <wd@denx.de> Cc: Joe Hershberger <joe.hershberger@ni.com> Cc: Patrick Delaunay <patrick.delaunay@st.com> Cc: uboot-stm32@st-md-mailman.stormreply.com Signed-off-by: Tom Rini <trini@konsulko.com> Acked-by: Joe Hershberger <joe.hershberger@ni.com> Reviewed-by: Simon Goldschmidt <simon.k.r.goldschmidt@gmail.com>
146 lines
4.9 KiB
C
146 lines
4.9 KiB
C
/* SPDX-License-Identifier: GPL-2.0+ */
|
|
/*
|
|
* Copyright (c) 2017 Toradex, Inc.
|
|
*
|
|
* Configuration settings for the Toradex Apalis TK1 modules.
|
|
*/
|
|
|
|
#ifndef __CONFIG_H
|
|
#define __CONFIG_H
|
|
|
|
#include <linux/sizes.h>
|
|
|
|
#include "tegra124-common.h"
|
|
|
|
#define CONFIG_ARCH_MISC_INIT
|
|
|
|
/* Board-specific serial config */
|
|
#define CONFIG_TEGRA_ENABLE_UARTA
|
|
#define CONFIG_SYS_NS16550_COM1 NV_PA_APB_UARTA_BASE
|
|
|
|
#define FDT_MODULE "apalis-v1.2"
|
|
#define FDT_MODULE_V1_0 "apalis"
|
|
|
|
/* Environment in eMMC, before config block at the end of 1st "boot sector" */
|
|
#define CONFIG_SYS_MMC_ENV_DEV 0
|
|
#define CONFIG_SYS_MMC_ENV_PART 1
|
|
|
|
/* PCI host support */
|
|
#undef CONFIG_PCI_SCAN_SHOW
|
|
|
|
/* PCI networking support */
|
|
#define CONFIG_E1000_NO_NVM
|
|
|
|
/* General networking support */
|
|
#define CONFIG_TFTP_TSIZE
|
|
|
|
#undef CONFIG_IPADDR
|
|
#define CONFIG_IPADDR 192.168.10.2
|
|
#define CONFIG_NETMASK 255.255.255.0
|
|
#undef CONFIG_SERVERIP
|
|
#define CONFIG_SERVERIP 192.168.10.1
|
|
|
|
#define DFU_ALT_EMMC_INFO "apalis-tk1.img raw 0x0 0x500 mmcpart 1; " \
|
|
"boot part 0 1 mmcpart 0; " \
|
|
"rootfs part 0 2 mmcpart 0; " \
|
|
"zImage fat 0 1 mmcpart 0; " \
|
|
"tegra124-apalis-eval.dtb fat 0 1 mmcpart 0"
|
|
|
|
#define EMMC_BOOTCMD \
|
|
"set_emmcargs=setenv emmcargs ip=off root=PARTUUID=${uuid} " \
|
|
"ro rootfstype=ext4 rootwait\0" \
|
|
"emmcboot=run setup; run emmcfinduuid; run set_emmcargs; " \
|
|
"setenv bootargs ${defargs} ${emmcargs} " \
|
|
"${setupargs} ${vidargs}; echo Booting from internal eMMC; " \
|
|
"run emmcdtbload; " \
|
|
"load mmc ${emmcdev}:${emmcbootpart} ${kernel_addr_r} " \
|
|
"${boot_file} && run fdt_fixup && " \
|
|
"bootz ${kernel_addr_r} - ${dtbparam}\0" \
|
|
"emmcbootpart=1\0" \
|
|
"emmcdev=0\0" \
|
|
"emmcdtbload=setenv dtbparam; load mmc ${emmcdev}:${emmcbootpart} " \
|
|
"${fdt_addr_r} ${soc}-${fdt_module}-${fdt_board}.dtb && " \
|
|
"setenv dtbparam ${fdt_addr_r}\0" \
|
|
"emmcfinduuid=part uuid mmc ${mmcdev}:${emmcrootpart} uuid\0" \
|
|
"emmcrootpart=2\0"
|
|
|
|
#define NFS_BOOTCMD \
|
|
"nfsargs=ip=:::::eth0:on root=/dev/nfs rw\0" \
|
|
"nfsboot=pci enum; run setup; setenv bootargs ${defargs} ${nfsargs} " \
|
|
"${setupargs} ${vidargs}; echo Booting via DHCP/TFTP/NFS...; " \
|
|
"run nfsdtbload; dhcp ${kernel_addr_r} " \
|
|
"&& run fdt_fixup && bootz ${kernel_addr_r} - ${dtbparam}\0" \
|
|
"nfsdtbload=setenv dtbparam; tftp ${fdt_addr_r} " \
|
|
"${soc}-${fdt_module}-${fdt_board}.dtb " \
|
|
"&& setenv dtbparam ${fdt_addr_r}\0"
|
|
|
|
#define SD_BOOTCMD \
|
|
"set_sdargs=setenv sdargs ip=off root=PARTUUID=${uuid} ro " \
|
|
"rootfstype=ext4 rootwait\0" \
|
|
"sdboot=run setup; run sdfinduuid; run set_sdargs; " \
|
|
"setenv bootargs ${defargs} ${sdargs} ${setupargs} " \
|
|
"${vidargs}; echo Booting from SD card in 8bit slot...; " \
|
|
"run sddtbload; load mmc ${sddev}:${sdbootpart} " \
|
|
"${kernel_addr_r} ${boot_file} && run fdt_fixup && " \
|
|
"bootz ${kernel_addr_r} - ${dtbparam}\0" \
|
|
"sdbootpart=1\0" \
|
|
"sddev=1\0" \
|
|
"sddtbload=setenv dtbparam; load mmc ${sddev}:${sdbootpart} " \
|
|
"${fdt_addr_r} ${soc}-${fdt_module}-${fdt_board}.dtb " \
|
|
"&& setenv dtbparam ${fdt_addr_r}\0" \
|
|
"sdfinduuid=part uuid mmc ${sddev}:${sdrootpart} uuid\0" \
|
|
"sdrootpart=2\0"
|
|
|
|
#define BOARD_EXTRA_ENV_SETTINGS \
|
|
"boot_file=zImage\0" \
|
|
"console=ttyS0\0" \
|
|
"defargs=lp0_vec=2064@0xf46ff000 core_edp_mv=1150 core_edp_ma=4000 " \
|
|
"usb_port_owner_info=2 lane_owner_info=6 emc_max_dvfs=0 " \
|
|
"user_debug=30 pcie_aspm=off\0" \
|
|
"dfu_alt_info=" DFU_ALT_EMMC_INFO "\0" \
|
|
EMMC_BOOTCMD \
|
|
"fdt_board=eval\0" \
|
|
"fdt_fixup=;\0" \
|
|
"fdt_module=" FDT_MODULE "\0" \
|
|
NFS_BOOTCMD \
|
|
SD_BOOTCMD \
|
|
"setethupdate=if env exists ethaddr; then; else setenv ethaddr " \
|
|
"00:14:2d:00:00:00; fi; pci enum && tftpboot ${loadaddr} " \
|
|
"flash_eth.img && source ${loadaddr}\0" \
|
|
"setsdupdate=setenv interface mmc; setenv drive 1; mmc rescan; " \
|
|
"load ${interface} ${drive}:1 ${loadaddr} flash_blk.img " \
|
|
"|| setenv drive 2; mmc rescan; load ${interface} ${drive}:1 " \
|
|
"${loadaddr} flash_blk.img && " \
|
|
"source ${loadaddr}\0" \
|
|
"setup=setenv setupargs igb_mac=${ethaddr} " \
|
|
"consoleblank=0 no_console_suspend=1 console=tty1 " \
|
|
"console=${console},${baudrate}n8 debug_uartport=lsport,0 " \
|
|
"${memargs}\0" \
|
|
"setupdate=run setsdupdate || run setusbupdate || run setethupdate\0" \
|
|
"setusbupdate=usb start && setenv interface usb; setenv drive 0; " \
|
|
"load ${interface} ${drive}:1 ${loadaddr} flash_blk.img && " \
|
|
"source ${loadaddr}\0" \
|
|
"vidargs=fbcon=map:1\0"
|
|
|
|
/* Increase console I/O buffer size */
|
|
#undef CONFIG_SYS_CBSIZE
|
|
#define CONFIG_SYS_CBSIZE 1024
|
|
|
|
/* Increase arguments buffer size */
|
|
#undef CONFIG_SYS_BARGSIZE
|
|
#define CONFIG_SYS_BARGSIZE CONFIG_SYS_CBSIZE
|
|
|
|
/* Increase maximum number of arguments */
|
|
#undef CONFIG_SYS_MAXARGS
|
|
#define CONFIG_SYS_MAXARGS 32
|
|
|
|
#define CONFIG_CMD_TIME
|
|
|
|
#include "tegra-common-usb-gadget.h"
|
|
#include "tegra-common-post.h"
|
|
|
|
/* Reserve top 1M for secure RAM */
|
|
#define CONFIG_ARMV7_SECURE_BASE 0xfff00000
|
|
#define CONFIG_ARMV7_SECURE_RESERVE_SIZE 0x00100000
|
|
|
|
#endif /* __CONFIG_H */
|