u-boot/board/solidrun/clearfog/Kconfig
Dennis Gilmore 9c690314db ARM: mvebu: ClearFog make sure that SATA and UART images are buildable
SATA and UART ClearFog imaages are not buildable as ENV_SECT_SIZE is not defined
set values for both possible targets

Signed-off-by: Dennis Gilmore <dennis@ausil.us>
2021-01-27 07:25:39 +01:00

62 lines
2.1 KiB
Text

menu "ClearFog configuration"
depends on TARGET_CLEARFOG
config TARGET_CLEARFOG_BASE
bool "Use ClearFog Base static configuration"
help
Use the ClearFog Base as the static configuration instead of the
default which uses the ClearFog Pro.
Runtime board detection is always attempted and used if available. The
static configuration is used as a fallback in cases where runtime
detection is disabled, is not available in hardware, or otherwise fails.
Only newer revisions of the ClearFog product line support runtime
detection via additional EEPROM hardware. This option enables selecting
the Base variant for older hardware revisions.
config CLEARFOG_CON3_SATA
bool "Use CON3 slot in SATA mode"
help
Use the CON3 port with SATA protocol instead of the default PCIe.
The ClearFog port allows usage of either mSATA or miniPCIe
modules, but the desired protocol must be configured at build
time since it affects the SerDes topology layout.
config CLEARFOG_CON2_SATA
bool "Use CON2 slot in SATA mode"
depends on !TARGET_CLEARFOG_BASE
help
Use the CON2 port with SATA protocol instead of the default PCIe.
The ClearFog port allows usage of either mSATA or miniPCIe
modules, but the desired protocol must be configured at build
time since it affects the SerDes topology layout.
config CLEARFOG_SFP_25GB
bool "Enable 2.5 Gbps mode for SFP"
help
Set the SFP module connection to support 2.5 Gbps transfer speed for the
SGMII connection (requires a supporting SFP). By default, transfer speed
of 1.25 Gbps is used, suitable for a more common 1 Gbps SFP module.
config ENV_SIZE
hex "Environment Size"
default 0x10000
config ENV_OFFSET
hex "Environment offset"
default 0xF0000
config ENV_SECT_SIZE
hex "Environment Sector-Size"
# Use SPI flash erase block size of 4 KiB
default 0x1000 if MVEBU_SPL_BOOT_DEVICE_SPI || MVEBU_SPL_BOOT_DEVICE_SATA
# Use optimistic 64 KiB erase block, will vary between actual media
default 0x10000 if MVEBU_SPL_BOOT_DEVICE_MMC || MVEBU_SPL_BOOT_DEVICE_UART
config SYS_SPI_U_BOOT_OFFS
hex "address of u-boot payload in SPI flash"
default 0x20000
depends on MVEBU_SPL_BOOT_DEVICE_SPI
endmenu