mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-06 13:14:27 +00:00
e37ac717d7
Converted to use fsl_esdhc_imx for i.MX platforms. Signed-off-by: Yangbo Lu <yangbo.lu@nxp.com> Tested-by: Steffen Dirkwinkel <s.dirkwinkel@beckhoff.com> Reviewed-by: Peng Fan <peng.fan@nxp.com> Reviewed-by: Lukasz Majewski <lukma@denx.de> Reviewed-by: Martyn Welch <martyn.welch@collabora.com> Acked-by: Jason Liu <Jason.hui.liu@nxp.com> |
||
|---|---|---|
| .. | ||
| dart_6ul.c | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| README | ||
| spl.c | ||
How to use U-Boot on variscite DART-6UL Evaluation Kit
------------------------------------------------------
- Configure and build U-Boot for DART-6UL iMX6ULL:
$ make mrproper
$ make variscite_dart6ul_defconfig
$ make
This will generate SPL and u-boot-dtb.img images.
Boot from MMC/SD:
- The SPL and u-boot-dtb.img images need to be flashed into the micro SD card:
$ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
$ sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync
- Boot mode settings:
Boot switch position: SW1 -> 0
SW2 -> 0
Boot from eMMC:
- if bootpart is not enabled by default, to enable under Linux
echo 0 >/sys/block/mmcblk1boot0/force_ro
mmc bootpart enable 1 1 /dev/mmcblk1boot0
- Flash the SPL and u-boot-dtb.img to mmcblk1boot0
$ sudo dd if=SPL of=/dev/mmcblk1boot0 bs=1k seek=1; sync
$ sudo dd if=u-boot-dtb.img of=/dev/mmcblk1boot0 bs=1k seek=69; sync
- Boot mode settings:
Boot switch position: SW1 -> 0
SW2 -> 1
- Connect the Serial cable to UART0 and the PC for the console.
- Insert the micro SD card in the board and power it up.
- U-Boot messages should come up.