u-boot/arch/arm/mach-imx/imx8/Kconfig
Peng Fan 0d331c035a imx: support i.MX8QM MEK board
Add i.MX8QM MEK board support.
Included a basic dts, enabled SPL FIT

Boot log as below:
U-Boot SPL 2019.01-rc1-00029-gf002213219 (Dec 24 2018 - 10:28:30 +0800)
Normal Boot
Trying to boot from MMC2_2

U-Boot 2019.01-rc1-00029-gf002213219 (Dec 24 2018 - 10:28:30 +0800)

CPU:   NXP i.MX8QM RevB A53 at 142933 MHz

Model: Freescale i.MX8QM MEK
Board: iMX8QM MEK
Build: SCFW 9330215b
Boot:  SD1
DRAM:  6 GiB
MMC:   FSL_SDHC: 0, FSL_SDHC: 1
Loading Environment from MMC... *** Warning - bad CRC, using default environment

In:    serial@5a060000
Out:   serial@5a060000
Err:   serial@5a060000
Net:
Error: ethernet@5b040000 address not set.
eth-1: ethernet@5b040000
Hit any key to stop autoboot:  0

Signed-off-by: Peng Fan <peng.fan@nxp.com>
2019-04-25 17:03:25 +02:00

45 lines
741 B
Text

if ARCH_IMX8
config IMX8
bool
config MU_BASE_SPL
hex "MU base address used in SPL"
default 0x5d1b0000
help
SPL runs in EL3 mode, it use MU0_A to communicate with SCU.
So we could not reuse the one in dts which is for normal U-Boot.
config IMX8QM
select IMX8
select SUPPORT_SPL
bool
config IMX8QXP
select IMX8
select SUPPORT_SPL
bool
config SYS_SOC
default "imx8"
choice
prompt "i.MX8 board select"
optional
config TARGET_IMX8QXP_MEK
bool "Support i.MX8QXP MEK board"
select BOARD_LATE_INIT
select IMX8QXP
config TARGET_IMX8QM_MEK
bool "Support i.MX8QM MEK board"
select BOARD_LATE_INIT
select IMX8QM
endchoice
source "board/freescale/imx8qxp_mek/Kconfig"
source "board/freescale/imx8qm_mek/Kconfig"
endif