mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-12-05 02:51:00 +00:00
e37ac717d7
Converted to use fsl_esdhc_imx for i.MX platforms. Signed-off-by: Yangbo Lu <yangbo.lu@nxp.com> Tested-by: Steffen Dirkwinkel <s.dirkwinkel@beckhoff.com> Reviewed-by: Peng Fan <peng.fan@nxp.com> Reviewed-by: Lukasz Majewski <lukma@denx.de> Reviewed-by: Martyn Welch <martyn.welch@collabora.com> Acked-by: Jason Liu <Jason.hui.liu@nxp.com> |
||
---|---|---|
.. | ||
Kconfig | ||
MAINTAINERS | ||
Makefile | ||
mx6ul_14x14_evk.c | ||
README |
How to use U-Boot on Freescale MX6UL 14x14 EVK ----------------------------------------------- - Build U-Boot for MX6UL 14x14 EVK: $ make mrproper $ make mx6ul_14x14_evk_defconfig $ make This will generate the SPL image called SPL and the u-boot.img. - Flash the SPL image into the micro SD card: sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync - Flash the u-boot.img image into the micro SD card: sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync - Jumper settings: SW601: 0 0 1 0 Sw602: 1 0 where 0 means bottom position and 1 means top position (from the switch label numbers reference). - Connect the USB cable between the EVK and the PC for the console. (The USB console connector is the one close the push buttons) - Insert the micro SD card in the board, power it up and U-Boot messages should come up.