u-boot/configs/Sinovoip_BPI_M3_defconfig
Andre Przywara 9340d8fe8b sunxi: move CONFIG_SPL_TEXT_BASE from *_defconfig to Kconfig
The choice of the SPL_TEXT_BASE is not really a decision that should be
specified by each board's defconfig, as this setting is actually
dictated by the SoC's memory map and the BootROM behaviour.

To make this obvious and reduce the clutter in the defconfig files,
let's specify the SoC constraints in the Kconfig stanza.
This allows us to remove these lines from the defconfig files again.

Signed-off-by: Andre Przywara <andre.przywara@arm.com>
Acked-by: Maxime Ripard <maxime.ripard@bootlin.com>
Reviewed-by: Jagan Teki <jagan@amarulasolutions.com>
2019-07-15 12:25:32 +05:30

32 lines
860 B
Text

CONFIG_ARM=y
CONFIG_ARCH_SUNXI=y
CONFIG_NR_DRAM_BANKS=1
CONFIG_SPL=y
CONFIG_MACH_SUN8I_A83T=y
CONFIG_DRAM_TYPE=7
CONFIG_DRAM_CLK=480
CONFIG_DRAM_ZQ=15355
CONFIG_DRAM_ODT_EN=y
CONFIG_MMC_SUNXI_SLOT_EXTRA=2
CONFIG_INITIAL_USB_SCAN_DELAY=500
CONFIG_USB0_VBUS_PIN="AXP0-VBUS-ENABLE"
CONFIG_USB0_VBUS_DET="AXP0-VBUS-DETECT"
CONFIG_USB0_ID_DET="PH11"
CONFIG_USB1_VBUS_PIN="PD24"
CONFIG_AXP_GPIO=y
CONFIG_SATAPWR="PD25"
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
CONFIG_CONSOLE_MUX=y
# CONFIG_CMD_FLASH is not set
# CONFIG_SPL_DOS_PARTITION is not set
# CONFIG_SPL_EFI_PARTITION is not set
CONFIG_DEFAULT_DEVICE_TREE="sun8i-a83t-bananapi-m3"
CONFIG_PHY_REALTEK=y
CONFIG_SUN8I_EMAC=y
CONFIG_AXP_DCDC5_VOLT=1200
CONFIG_AXP_DLDO3_VOLT=3300
CONFIG_AXP_SW_ON=y
CONFIG_USB_EHCI_HCD=y
CONFIG_USB_OHCI_HCD=y
CONFIG_USB_MUSB_HOST=y
CONFIG_SYS_USB_EVENT_POLL_VIA_INT_QUEUE=y