mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-18 18:59:44 +00:00
d8d33b6d4d
Port for the DART-6UL Evaluation Kit SBC. Based on the variscite DART-6UL iMX6ULL SoM. CPU: Freescale i.MX6ULL rev1.1 900 MHz (running at 396 MHz) CPU: Commercial temperature grade (0C to 95C) at 43C Reset cause: POR Model: Variscite DART-6UL Evaluation Kit Board: Variscite DART-6UL Evaluation Kit DRAM: 512 MiB MMC: FSL_SDHC: 0, FSL_SDHC: 1 In: serial@02020000 Out: serial@02020000 Err: serial@02020000 Net: FEC0 Working: - Eth0 - i2c - MMC/SD - eMMC - USB host - UART 1 Note: LCDIF porting needs DM_VIDEO https://lists.denx.de/pipermail/u-boot/2019-April/365506.html Signed-off-by: Parthiban Nallathambi <parthitce@gmail.com>
41 lines
1.1 KiB
Text
41 lines
1.1 KiB
Text
How to use U-Boot on variscite DART-6UL Evaluation Kit
|
|
------------------------------------------------------
|
|
|
|
- Configure and build U-Boot for DART-6UL iMX6ULL:
|
|
|
|
$ make mrproper
|
|
$ make variscite_dart6ul_defconfig
|
|
$ make
|
|
|
|
This will generate SPL and u-boot-dtb.img images.
|
|
|
|
Boot from MMC/SD:
|
|
- The SPL and u-boot-dtb.img images need to be flashed into the micro SD card:
|
|
|
|
$ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync
|
|
$ sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync
|
|
|
|
- Boot mode settings:
|
|
|
|
Boot switch position: SW1 -> 0
|
|
SW2 -> 0
|
|
|
|
Boot from eMMC:
|
|
- if bootpart is not enabled by default, to enable under Linux
|
|
echo 0 >/sys/block/mmcblk1boot0/force_ro
|
|
mmc bootpart enable 1 1 /dev/mmcblk1boot0
|
|
|
|
- Flash the SPL and u-boot-dtb.img to mmcblk1boot0
|
|
$ sudo dd if=SPL of=/dev/mmcblk1boot0 bs=1k seek=1; sync
|
|
$ sudo dd if=u-boot-dtb.img of=/dev/mmcblk1boot0 bs=1k seek=69; sync
|
|
|
|
- Boot mode settings:
|
|
|
|
Boot switch position: SW1 -> 0
|
|
SW2 -> 1
|
|
|
|
- Connect the Serial cable to UART0 and the PC for the console.
|
|
|
|
- Insert the micro SD card in the board and power it up.
|
|
|
|
- U-Boot messages should come up.
|