mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-12-13 23:02:59 +00:00
bc2d40ca10
In the earlier patches, the SPL/TPL fraamework was introduced. For SD/SPI flash booting way, we introduce the SPL to enable a loader stub. The SPL was loaded by the code from the internal on-chip ROM. The SPL initializes the DDR according to the SPD and loads the final uboot image into DDR, then jump to the DDR to begin execution. For NAND booting way, the nand SPL has size limitation on some board(e.g. P1010RDB), it can not be more than 4KB, we can call it "minimal SPL", So the dynamic DDR driver doesn't fit into this minimum SPL. We added the TPL that is loaded by the the minimal SPL. The TPL initializes the DDR according to the SPD and loads the final uboot image into DDR,then jump to the DDR to begin execution. This patch enabled SPL/TPL for P1_P2_RDB to support starting from NAND/SD/SPI flash with SPL framework and initializing the DDR according to SPD in the SPL/TPL. Because the minimal SPL load the TPL to L2 SRAM and the jump to the L2 SRAM to execute, so the section .resetvec is no longer needed. Signed-off-by: Prabhakar Kushwaha <prabhakar@freescale.com> Reviewed-by: York Sun <yorksun@freescale.com>
30 lines
382 B
Makefile
30 lines
382 B
Makefile
#
|
|
# Copyright 2009 Freescale Semiconductor, Inc.
|
|
#
|
|
# SPDX-License-Identifier: GPL-2.0+
|
|
#
|
|
|
|
MINIMAL=
|
|
|
|
ifdef CONFIG_SPL_BUILD
|
|
ifdef CONFIG_SPL_INIT_MINIMAL
|
|
MINIMAL=y
|
|
endif
|
|
endif
|
|
|
|
ifdef MINIMAL
|
|
|
|
obj-y += spl_minimal.o tlb.o law.o
|
|
|
|
else
|
|
ifdef CONFIG_SPL_BUILD
|
|
obj-y += spl.o
|
|
else
|
|
obj-y += p1_p2_rdb.o
|
|
obj-$(CONFIG_PCI) += pci.o
|
|
endif
|
|
obj-y += ddr.o
|
|
obj-y += law.o
|
|
obj-y += tlb.o
|
|
|
|
endif
|