u-boot/env/sf.c
Lukasz Majewski 56c4046038 spi: Convert CONFIG_DM_SPI* to CONFIG_$(SPL_TPL_)DM_SPI*
This change allows more fine tuning of driver model based SPI support in
SPL and TPL. It is now possible to explicitly enable/disable the DM_SPI
support in SPL and TPL via Kconfig option.

Before this change it was necessary to use:
    /* SPI Flash Configs */
    #if defined(CONFIG_SPL_BUILD)
    #undef CONFIG_DM_SPI
    #undef CONFIG_DM_SPI_FLASH
    #undef CONFIG_SPI_FLASH_MTD
    #endif

in the ./include/configs/<board>.h, which is error prone and shall be
avoided when we strive to switch to Kconfig.

The goal of this patch:

Provide distinction for DM_SPI support in both U-Boot proper and SPL (TPL).
Valid use case is when U-Boot proper wants to use DM_SPI, but SPL must
still support non DM driver.

Another use case is the conversion of non DM/DTS SPI driver to support
DM/DTS. When such driver needs to work in both SPL and U-Boot proper, the
distinction is needed in Kconfig (also if SPL version of the driver
supports OF_PLATDATA).

In the end of the day one would have to support following use cases (in
single driver file - e.g. mxs_spi.c):

- U-Boot proper driver supporting DT/DTS
- U-Boot proper driver without DT/DTS support (deprecated)
- SPL driver without DT/DTS support
- SPL (and TPL) driver with DT/DTS (when the SoC has enough resources to
  run full blown DT/DTS)
- SPL driver with DT/DTS and SPL_OF_PLATDATA (when one have constrained
  environment with no fitImage and OF_LIBFDT support).

Some boards do require SPI support (with DM) in SPL (TPL) and some only
have DM_SPI{_FLASH} defined to allow compiling SPL.

This patch converts #ifdef CONFIG_DM_SPI* to #if CONFIG_IS_ENABLED(DM_SPI)
and provides corresponding defines in Kconfig.

Signed-off-by: Lukasz Majewski <lukma@denx.de>
Tested-by: Adam Ford <aford173@gmail.com> #da850-evm
Signed-off-by: Hou Zhiqiang <Zhiqiang.Hou@nxp.com>
[trini: Fixup a few platforms]
Signed-off-by: Tom Rini <trini@konsulko.com>
2020-06-29 13:34:43 -04:00

314 lines
6.5 KiB
C

// SPDX-License-Identifier: GPL-2.0+
/*
* (C) Copyright 2000-2010
* Wolfgang Denk, DENX Software Engineering, wd@denx.de.
*
* (C) Copyright 2001 Sysgo Real-Time Solutions, GmbH <www.elinos.com>
* Andreas Heppel <aheppel@sysgo.de>
*
* (C) Copyright 2008 Atmel Corporation
*/
#include <common.h>
#include <dm.h>
#include <env.h>
#include <env_internal.h>
#include <flash.h>
#include <malloc.h>
#include <spi.h>
#include <spi_flash.h>
#include <search.h>
#include <errno.h>
#include <uuid.h>
#include <asm/cache.h>
#include <dm/device-internal.h>
#include <u-boot/crc.h>
#ifndef CONFIG_SPL_BUILD
#define INITENV
#endif
#ifdef CONFIG_ENV_OFFSET_REDUND
static ulong env_offset = CONFIG_ENV_OFFSET;
static ulong env_new_offset = CONFIG_ENV_OFFSET_REDUND;
#endif /* CONFIG_ENV_OFFSET_REDUND */
DECLARE_GLOBAL_DATA_PTR;
static struct spi_flash *env_flash;
static int setup_flash_device(void)
{
#if CONFIG_IS_ENABLED(DM_SPI_FLASH)
struct udevice *new;
int ret;
/* speed and mode will be read from DT */
ret = spi_flash_probe_bus_cs(CONFIG_ENV_SPI_BUS, CONFIG_ENV_SPI_CS,
CONFIG_ENV_SPI_MAX_HZ, CONFIG_ENV_SPI_MODE,
&new);
if (ret) {
env_set_default("spi_flash_probe_bus_cs() failed", 0);
return ret;
}
env_flash = dev_get_uclass_priv(new);
#else
if (env_flash)
spi_flash_free(env_flash);
env_flash = spi_flash_probe(CONFIG_ENV_SPI_BUS, CONFIG_ENV_SPI_CS,
CONFIG_ENV_SPI_MAX_HZ, CONFIG_ENV_SPI_MODE);
if (!env_flash) {
env_set_default("spi_flash_probe() failed", 0);
return -EIO;
}
#endif
return 0;
}
#if defined(CONFIG_ENV_OFFSET_REDUND)
static int env_sf_save(void)
{
env_t env_new;
char *saved_buffer = NULL, flag = ENV_REDUND_OBSOLETE;
u32 saved_size, saved_offset, sector;
int ret;
ret = setup_flash_device();
if (ret)
return ret;
ret = env_export(&env_new);
if (ret)
return -EIO;
env_new.flags = ENV_REDUND_ACTIVE;
if (gd->env_valid == ENV_VALID) {
env_new_offset = CONFIG_ENV_OFFSET_REDUND;
env_offset = CONFIG_ENV_OFFSET;
} else {
env_new_offset = CONFIG_ENV_OFFSET;
env_offset = CONFIG_ENV_OFFSET_REDUND;
}
/* Is the sector larger than the env (i.e. embedded) */
if (CONFIG_ENV_SECT_SIZE > CONFIG_ENV_SIZE) {
saved_size = CONFIG_ENV_SECT_SIZE - CONFIG_ENV_SIZE;
saved_offset = env_new_offset + CONFIG_ENV_SIZE;
saved_buffer = memalign(ARCH_DMA_MINALIGN, saved_size);
if (!saved_buffer) {
ret = -ENOMEM;
goto done;
}
ret = spi_flash_read(env_flash, saved_offset,
saved_size, saved_buffer);
if (ret)
goto done;
}
sector = DIV_ROUND_UP(CONFIG_ENV_SIZE, CONFIG_ENV_SECT_SIZE);
puts("Erasing SPI flash...");
ret = spi_flash_erase(env_flash, env_new_offset,
sector * CONFIG_ENV_SECT_SIZE);
if (ret)
goto done;
puts("Writing to SPI flash...");
ret = spi_flash_write(env_flash, env_new_offset,
CONFIG_ENV_SIZE, &env_new);
if (ret)
goto done;
if (CONFIG_ENV_SECT_SIZE > CONFIG_ENV_SIZE) {
ret = spi_flash_write(env_flash, saved_offset,
saved_size, saved_buffer);
if (ret)
goto done;
}
ret = spi_flash_write(env_flash, env_offset + offsetof(env_t, flags),
sizeof(env_new.flags), &flag);
if (ret)
goto done;
puts("done\n");
gd->env_valid = gd->env_valid == ENV_REDUND ? ENV_VALID : ENV_REDUND;
printf("Valid environment: %d\n", (int)gd->env_valid);
done:
if (saved_buffer)
free(saved_buffer);
return ret;
}
static int env_sf_load(void)
{
int ret;
int read1_fail, read2_fail;
env_t *tmp_env1, *tmp_env2;
tmp_env1 = (env_t *)memalign(ARCH_DMA_MINALIGN,
CONFIG_ENV_SIZE);
tmp_env2 = (env_t *)memalign(ARCH_DMA_MINALIGN,
CONFIG_ENV_SIZE);
if (!tmp_env1 || !tmp_env2) {
env_set_default("malloc() failed", 0);
ret = -EIO;
goto out;
}
ret = setup_flash_device();
if (ret)
goto out;
read1_fail = spi_flash_read(env_flash, CONFIG_ENV_OFFSET,
CONFIG_ENV_SIZE, tmp_env1);
read2_fail = spi_flash_read(env_flash, CONFIG_ENV_OFFSET_REDUND,
CONFIG_ENV_SIZE, tmp_env2);
ret = env_import_redund((char *)tmp_env1, read1_fail, (char *)tmp_env2,
read2_fail);
spi_flash_free(env_flash);
env_flash = NULL;
out:
free(tmp_env1);
free(tmp_env2);
return ret;
}
#else
static int env_sf_save(void)
{
u32 saved_size, saved_offset, sector;
char *saved_buffer = NULL;
int ret = 1;
env_t env_new;
ret = setup_flash_device();
if (ret)
return ret;
/* Is the sector larger than the env (i.e. embedded) */
if (CONFIG_ENV_SECT_SIZE > CONFIG_ENV_SIZE) {
saved_size = CONFIG_ENV_SECT_SIZE - CONFIG_ENV_SIZE;
saved_offset = CONFIG_ENV_OFFSET + CONFIG_ENV_SIZE;
saved_buffer = malloc(saved_size);
if (!saved_buffer)
goto done;
ret = spi_flash_read(env_flash, saved_offset,
saved_size, saved_buffer);
if (ret)
goto done;
}
ret = env_export(&env_new);
if (ret)
goto done;
sector = DIV_ROUND_UP(CONFIG_ENV_SIZE, CONFIG_ENV_SECT_SIZE);
puts("Erasing SPI flash...");
ret = spi_flash_erase(env_flash, CONFIG_ENV_OFFSET,
sector * CONFIG_ENV_SECT_SIZE);
if (ret)
goto done;
puts("Writing to SPI flash...");
ret = spi_flash_write(env_flash, CONFIG_ENV_OFFSET,
CONFIG_ENV_SIZE, &env_new);
if (ret)
goto done;
if (CONFIG_ENV_SECT_SIZE > CONFIG_ENV_SIZE) {
ret = spi_flash_write(env_flash, saved_offset,
saved_size, saved_buffer);
if (ret)
goto done;
}
ret = 0;
puts("done\n");
done:
if (saved_buffer)
free(saved_buffer);
return ret;
}
static int env_sf_load(void)
{
int ret;
char *buf = NULL;
buf = (char *)memalign(ARCH_DMA_MINALIGN, CONFIG_ENV_SIZE);
if (!buf) {
env_set_default("malloc() failed", 0);
return -EIO;
}
ret = setup_flash_device();
if (ret)
goto out;
ret = spi_flash_read(env_flash,
CONFIG_ENV_OFFSET, CONFIG_ENV_SIZE, buf);
if (ret) {
env_set_default("spi_flash_read() failed", 0);
goto err_read;
}
ret = env_import(buf, 1);
if (!ret)
gd->env_valid = ENV_VALID;
err_read:
spi_flash_free(env_flash);
env_flash = NULL;
out:
free(buf);
return ret;
}
#endif
#if CONFIG_ENV_ADDR != 0x0
__weak void *env_sf_get_env_addr(void)
{
return (void *)CONFIG_ENV_ADDR;
}
#endif
#if defined(INITENV) && (CONFIG_ENV_ADDR != 0x0)
static int env_sf_init(void)
{
env_t *env_ptr = (env_t *)env_sf_get_env_addr();
if (crc32(0, env_ptr->data, ENV_SIZE) == env_ptr->crc) {
gd->env_addr = (ulong)&(env_ptr->data);
gd->env_valid = 1;
} else {
gd->env_addr = (ulong)&default_environment[0];
gd->env_valid = 1;
}
return 0;
}
#endif
U_BOOT_ENV_LOCATION(sf) = {
.location = ENVL_SPI_FLASH,
ENV_NAME("SPI Flash")
.load = env_sf_load,
.save = CONFIG_IS_ENABLED(SAVEENV) ? ENV_SAVE_PTR(env_sf_save) : NULL,
#if defined(INITENV) && (CONFIG_ENV_ADDR != 0x0)
.init = env_sf_init,
#endif
};