mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-25 22:20:45 +00:00
871ec6da42
Boot from MMC: ------------- U-Boot SPL 2016.11-rc2-g217bd8e-dirty (Nov 08 2016 - 22:59:44) Trying to boot from MMC1 U-Boot 2016.11-rc2-g217bd8e-dirty (Nov 08 2016 - 22:59:44 +0530) CPU: Freescale i.MX6D rev1.2 at 792 MHz Reset cause: POR Model: Engicam i.CoreM6 Quad/Dual RQS Starter Kit DRAM: 512 MiB MMC: FSL_SDHC: 0 *** Warning - bad CRC, using default environment In: serial Out: serial Err: serial Net: CPU Net Initialization Failed No ethernet found. Hit any key to stop autoboot: 0 icorem6qdl-rqs> Cc: Stefano Babic <sbabic@denx.de> Cc: Matteo Lisi <matteo.lisi@engicam.com> Cc: Michael Trimarchi <michael@amarulasolutions.com> Signed-off-by: Jagan Teki <jagan@amarulasolutions.com> |
||
|---|---|---|
| .. | ||
| icorem6_rqs.c | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| README | ||
How to use U-Boot on Engicam i.CoreM6 RQS Quad/Dual Starter Kit: ---------------------------------------------------------------- $ make mrproper - Configure U-Boot for Engicam i.CoreM6 RQS Quad/Dual: $ make imx6q_icore_rqs_mmc_defconfig - Build U-Boot $ make This will generate the SPL image called SPL and the u-boot-dtb.img. - Flash the SPL image into the micro SD card: sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync - Flash the u-boot-dtb.img image into the micro SD card: sudo dd if=u-boot-dtb.img of=/dev/mmcblk0 bs=1k seek=69; sync - Jumper settings: MMC Boot: JM3 Closed - Connect the Serial cable between the Starter Kit and the PC for the console. (J28 is the Linux Serial console connector) - Insert the micro SD card in the board, power it up and U-Boot messages should come up.