u-boot/board/freescale/mx6ul_14x14_evk
Ye Li 1a8c01995f imx: imx6ul_evk: Enable DM driver for iMX6UL EVK u-boot
Convert the codes and configurations to enable DM drivers in u-boot for
modules: i2c, PMIC, regulator, USB, Ethernet, SD/MMC, GPIO and QSPI

This patch does not change SPL, so it still uses non-DM driver for
UART, GPIO and SD/MMC.

Signed-off-by: Ye Li <ye.li@nxp.com>
2018-09-04 08:47:23 +02:00
..
Kconfig mx6: remove SYS_SOC from board Kconfig 2015-09-13 10:37:29 +02:00
MAINTAINERS MAINTAINERS: Update Peng Fan's email address 2016-03-02 14:48:52 +01:00
Makefile SPDX: Convert all of our single license tags to Linux Kernel style 2018-05-07 09:34:12 -04:00
mx6ul_14x14_evk.c imx: imx6ul_evk: Enable DM driver for iMX6UL EVK u-boot 2018-09-04 08:47:23 +02:00
README Use correct spelling of "U-Boot" 2016-02-06 12:00:59 +01:00

How to use U-Boot on Freescale MX6UL 14x14 EVK
-----------------------------------------------

- Build U-Boot for MX6UL 14x14 EVK:

$ make mrproper
$ make mx6ul_14x14_evk_defconfig
$ make

This will generate the SPL image called SPL and the u-boot.img.

- Flash the SPL image into the micro SD card:

sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync

- Flash the u-boot.img image into the micro SD card:

sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync

- Jumper settings:

SW601: 0 0 1 0
Sw602: 1 0

where 0 means bottom position and 1 means top position (from the
switch label numbers reference).

- Connect the USB cable between the EVK and the PC for the console.
(The USB console connector is the one close the push buttons)

- Insert the micro SD card in the board, power it up and U-Boot messages should
come up.