mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-07 21:54:45 +00:00
4e267b92fb
This patch enable convert DM MMC for imx7d-pico board and variant. Before the DM conversion only usdhc3 was enabled and therefore it appeared as MMC 0 to u-boot. After enabling MMC DM though usdhc3 defaults to MMC 2, which left unattended would drive changes to existing pico-pi bootscripts and environment variables that rely on mmc 0. Setup the alias of mmc0 and usdhc3 so that existing pico-imx7d boot code will work unmodified. When converting to DM_MMC it is necessary that SPL initializes eMMC by itself, so move the original eMMC initialization from U-Boot proper to SPL. Signed-off-by: Joris Offouga <offougajoris@gmail.com> Signed-off-by: Fabio Estevam <festevam@gmail.com> |
||
|---|---|---|
| .. | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| pico-imx7d.c | ||
| README | ||
| spl.c | ||
How to update U-Boot on pico-imx7d board ---------------------------------------- Required software on the host PC: - imx_usb_loader: https://github.com/boundarydevices/imx_usb_loader Build U-Boot for pico: $ make mrproper $ make pico-imx7d_defconfig $ make This generates the SPL and u-boot.img binaries. 1. Loading U-Boot via USB Serial Download Protocol Note: This method is convenient for development purposes. If the eMMC has already a U-Boot flashed with DFU support then the user can go to step 2 below in order to update U-Boot. Put pico board in USB download mode (refer to the PICO-iMX7D Quick Start Guide page 3) Connect a USB to serial adapter between the host PC and pico. Connect a USB cable between the OTG pico port and the host PC. Note: Some computers may be a bit strict with USB current draw and will shut down their ports if the draw is too high. The solution for that is to use an externally powered USB hub between the board and the host computer. Open a terminal program such as minicom. Copy SPL and u-boot.img to the imx_usb_loader folder. Load the SPL binary via USB: $ sudo ./imx_usb SPL Load the u-boot.img binary via USB: $ sudo ./imx_usb u-boot.img Then U-Boot starts and its messages appear in the console program. Use the default environment variables: => env default -f -a => saveenv 2. Flashing U-Boot into the eMMC Run the DFU agent so we can flash the new images using dfu-util tool: => dfu 0 mmc 0 Flash SPL and u-boot.img into the eMMC running the following commands on a PC: $ sudo dfu-util -D SPL -a spl $ sudo dfu-util -D u-boot.img -a u-boot Remove power from the pico board. Put pico board into normal boot mode. Power up the board and the new updated U-Boot should boot from eMMC.