u-boot/board/st/stm32mp1/spl.c
Patrick Delaunay 178a415534 stpmic1: program pmic to keep only the debug unit on
Depending on backup register value, we maintain the debug unit
powered-on for debugging purpose.
Only BUCK1 is required for powering the debug unit, so revert
the setting for all the other power lanes, except BUCK3 that
has to be always on.

Signed-off-by: Patrick Delaunay <patrick.delaunay@st.com>
2019-08-27 09:36:56 +02:00

45 lines
1.1 KiB
C

// SPDX-License-Identifier: GPL-2.0+ OR BSD-3-Clause
/*
* Copyright (C) 2018, STMicroelectronics - All Rights Reserved
*/
#include <config.h>
#include <common.h>
#include <spl.h>
#include <dm.h>
#include <ram.h>
#include <asm/io.h>
#include <power/pmic.h>
#include <power/stpmic1.h>
#include <asm/arch/ddr.h>
void spl_board_init(void)
{
/* Keep vdd on during the reset cycle */
#if defined(CONFIG_PMIC_STPMIC1) && defined(CONFIG_SPL_POWER_SUPPORT)
struct udevice *dev;
int ret;
ret = uclass_get_device_by_driver(UCLASS_PMIC,
DM_GET_DRIVER(pmic_stpmic1), &dev);
if (!ret)
pmic_clrsetbits(dev,
STPMIC1_BUCKS_MRST_CR,
STPMIC1_MRST_BUCK(STPMIC1_BUCK3),
STPMIC1_MRST_BUCK(STPMIC1_BUCK3));
/* Check if debug is enabled to program PMIC according to the bit */
if ((readl(TAMP_BOOT_CONTEXT) & TAMP_BOOT_DEBUG_ON) && !ret) {
printf("Keep debug unit ON\n");
pmic_clrsetbits(dev, STPMIC1_BUCKS_MRST_CR,
STPMIC1_MRST_BUCK_DEBUG,
STPMIC1_MRST_BUCK_DEBUG);
if (STPMIC1_MRST_LDO_DEBUG)
pmic_clrsetbits(dev, STPMIC1_LDOS_MRST_CR,
STPMIC1_MRST_LDO_DEBUG,
STPMIC1_MRST_LDO_DEBUG);
}
#endif
}