mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-16 01:38:22 +00:00
83d290c56f
When U-Boot started using SPDX tags we were among the early adopters and there weren't a lot of other examples to borrow from. So we picked the area of the file that usually had a full license text and replaced it with an appropriate SPDX-License-Identifier: entry. Since then, the Linux Kernel has adopted SPDX tags and they place it as the very first line in a file (except where shebangs are used, then it's second line) and with slightly different comment styles than us. In part due to community overlap, in part due to better tag visibility and in part for other minor reasons, switch over to that style. This commit changes all instances where we have a single declared license in the tag as both the before and after are identical in tag contents. There's also a few places where I found we did not have a tag and have introduced one. Signed-off-by: Tom Rini <trini@konsulko.com> |
||
|---|---|---|
| .. | ||
| flash.c | ||
| Kconfig | ||
| lowlevel_init.S | ||
| MAINTAINERS | ||
| Makefile | ||
| pb1x00.c | ||
| README | ||
By Thomas.Lange@corelatus.se 2004-Oct-05 ---------------------------------------- DbAu1xx0 are development boards from AMD containing an Alchemy AU1xx0 series cpu with mips32 core. Existing cpu:s are Au1000, Au1100, Au1500 and Au1550 Limitations & comments ---------------------- Support was originally big endian only. I have not tested, but several u-boot users report working configurations in little endian mode. I named the board dbau1x00, to allow support for all three development boards ( dbau1000, dbau1100 and dbau1500 ). Now there is a new board called dbau1550 also, which should be supported RSN. I only have a dbau1000, so my testing is limited to this board. The board has two different flash banks, that can be selected via dip switch. This makes it possible to test new bootloaders without thrashing the YAMON boot loader delivered with board. NOTE! When you switch between the two boot flashes, the base addresses will be swapped. Have this in mind when you compile u-boot. CONFIG_SYS_TEXT_BASE has to match the address where u-boot is located when you actually launch. Ethernet only supported for mac0. PCMCIA only supported for slot 0, only 3.3V. PCMCIA IDE tested with Sandisk Compact Flash and IBM microdrive. ################################### ######## NOTE!!!!!! ######### ################################### If you partition a disk on another system (e.g. laptop), all bytes will be swapped on 16bit level when using PCMCIA and running cpu in big endian mode!!!! This is probably due to an error in Au1000 chip. Solution: a) Boot via network and partition disk directly from dbau1x00. The endian will then be correct. b) Partition disk on "laptop" and fill it with all files you need. Then write a simple program that endian swaps whole disk, Example: Original "laptop" byte order: B0 B1 B2 B3 B4 B5 B6 B7 B8 B9... Dbau1000 byte order will then be: B1 B0 B3 B2 B5 B4 B7 B6 B9 B8...