u-boot/arch/arm/dts/imx8mm-evk-u-boot.dtsi
Tim Harvey 93cac45c97 arm: dts: imx8m: move CAAM nodes into common u-boot.dtsi
Move the crypto and sec_jr* nodes from board-specific
u-boot.dtsi files into the common files. Additionally protect the
nodes with ifdef CONFIG_FSL_CAAM as they don't serve any purpose if
that is not enabled.

Signed-off-by: Tim Harvey <tharvey@gateworks.com>
Reviewed-by: Marcel Ziswiler <marcel.ziswiler@toradex.com>
2023-10-16 08:46:01 +02:00

127 lines
1.3 KiB
Text

// SPDX-License-Identifier: GPL-2.0+
/*
* Copyright 2019, 2021 NXP
*/
#include "imx8mm-u-boot.dtsi"
/ {
wdt-reboot {
compatible = "wdt-reboot";
wdt = <&wdog1>;
bootph-pre-ram;
};
};
&aips4 {
bootph-pre-ram;
};
&reg_usdhc2_vmmc {
u-boot,off-on-delay-us = <20000>;
};
&pinctrl_reg_usdhc2_vmmc {
bootph-pre-ram;
};
&pinctrl_uart2 {
bootph-pre-ram;
};
&pinctrl_usdhc2_gpio {
bootph-pre-ram;
};
&pinctrl_usdhc2 {
bootph-pre-ram;
};
&pinctrl_usdhc3 {
bootph-pre-ram;
};
&gpio1 {
bootph-pre-ram;
};
&gpio2 {
bootph-pre-ram;
};
&gpio3 {
bootph-pre-ram;
};
&gpio4 {
bootph-pre-ram;
};
&gpio5 {
bootph-pre-ram;
};
&uart2 {
bootph-pre-ram;
};
&usbmisc1 {
bootph-pre-ram;
};
&usbphynop1 {
bootph-pre-ram;
};
&usbotg1 {
bootph-pre-ram;
};
&usdhc1 {
bootph-pre-ram;
};
&usdhc2 {
bootph-pre-ram;
sd-uhs-sdr104;
sd-uhs-ddr50;
fsl,signal-voltage-switch-extra-delay-ms = <8>;
};
&usdhc3 {
bootph-pre-ram;
mmc-hs400-1_8v;
mmc-hs400-enhanced-strobe;
};
&i2c1 {
bootph-pre-ram;
};
&{/soc@0/bus@30800000/i2c@30a20000/pmic@4b} {
bootph-pre-ram;
};
&{/soc@0/bus@30800000/i2c@30a20000/pmic@4b/regulators} {
bootph-pre-ram;
};
&pinctrl_i2c1 {
bootph-pre-ram;
};
&pinctrl_pmic {
bootph-pre-ram;
};
&pinctrl_wdog {
bootph-pre-ram;
};
&fec1 {
phy-reset-gpios = <&gpio4 22 GPIO_ACTIVE_LOW>;
};
&wdog1 {
bootph-pre-ram;
};