mirror of
https://github.com/AsahiLinux/u-boot
synced 2024-11-26 06:30:39 +00:00
83d290c56f
When U-Boot started using SPDX tags we were among the early adopters and there weren't a lot of other examples to borrow from. So we picked the area of the file that usually had a full license text and replaced it with an appropriate SPDX-License-Identifier: entry. Since then, the Linux Kernel has adopted SPDX tags and they place it as the very first line in a file (except where shebangs are used, then it's second line) and with slightly different comment styles than us. In part due to community overlap, in part due to better tag visibility and in part for other minor reasons, switch over to that style. This commit changes all instances where we have a single declared license in the tag as both the before and after are identical in tag contents. There's also a few places where I found we did not have a tag and have introduced one. Signed-off-by: Tom Rini <trini@konsulko.com> |
||
|---|---|---|
| .. | ||
| Kconfig | ||
| MAINTAINERS | ||
| Makefile | ||
| README | ||
| spl.c | ||
| wandboard.c | ||
U-Boot for Wandboard -------------------- This file contains information for the port of U-Boot to the Wandboard. Wandboard is a development board that has three variants based on the following SoCs: mx6 quad, mx6 dual lite and mx6 solo. For more details about Wandboard, please refer to: http://www.wandboard.org/ Building U-Boot for Wandboard ----------------------------- To build U-Boot for the Wandboard: $ make wandboard_config $ make Flashing U-Boot into the SD card -------------------------------- - After the 'make' command completes, the generated 'SPL' binary must be flashed into the SD card; $ sudo dd if=SPL of=/dev/mmcblk0 bs=1k seek=1; sync (Note - the SD card node may vary, so adjust this as needed). - Flash the u-boot.img image into the SD card: sudo dd if=u-boot.img of=/dev/mmcblk0 bs=1k seek=69; sync - Insert the SD card into the slot located in the bottom of the board (same side as the mx6 processor) - Connect the serial cable to the host PC - Power up the board and U-Boot messages will appear in the serial console.