u-boot/configs/MSI_Primo81_defconfig
Alexander Graf 4f67b93fb7 part: Disable CONFIG_SPL_ISO_PARTITION by default
We enabled CONFIG_ISO_PARTITION by default for distro boot, so that U-Boot
could load distro images that usually get shipped as iso images. These images
usually come with a board agnostic boot environment.

However, there is very little point in having ISO support enabled (for anyone
really) in SPL, as the whole idea of SPL is to load U-Boot proper which again
is board specific. So the fact that we enable ISO support in U-Boot proper does
not mean at all that we want ISO support in U-Boot SPL.

Hence, let's remove the Kconfig dependency. Along the way, let's also clean up
all those default configs that disabled SPL ISO support.

Signed-off-by: Alexander Graf <agraf@suse.de>
2018-04-16 18:45:35 -04:00

28 lines
970 B
Text

CONFIG_ARM=y
CONFIG_ARCH_SUNXI=y
CONFIG_SPL=y
CONFIG_MACH_SUN6I=y
CONFIG_DRAM_CLK=360
CONFIG_DRAM_ZQ=122
CONFIG_USB0_VBUS_PIN="AXP0-VBUS-ENABLE"
CONFIG_USB0_VBUS_DET="AXP0-VBUS-DETECT"
CONFIG_AXP_GPIO=y
CONFIG_VIDEO_LCD_MODE="x:768,y:1024,depth:18,pclk_khz:66000,le:56,ri:60,up:30,lo:36,hs:64,vs:50,sync:3,vmode:0"
CONFIG_VIDEO_LCD_BL_EN="PA25"
CONFIG_VIDEO_LCD_BL_PWM="PH13"
CONFIG_VIDEO_LCD_PANEL_MIPI_4_LANE_513_MBPS_VIA_SSD2828=y
CONFIG_DEFAULT_DEVICE_TREE="sun6i-a31s-primo81"
# CONFIG_SYS_MALLOC_CLEAR_ON_INIT is not set
# CONFIG_CMD_FLASH is not set
# CONFIG_SPL_DOS_PARTITION is not set
# CONFIG_SPL_EFI_PARTITION is not set
CONFIG_AXP_DLDO1_VOLT=3300
# CONFIG_REQUIRE_SERIAL_CONSOLE is not set
CONFIG_USB_MUSB_HOST=y
CONFIG_SYS_USB_EVENT_POLL_VIA_INT_QUEUE=y
CONFIG_VIDEO_LCD_SSD2828_TX_CLK=27
CONFIG_VIDEO_LCD_SSD2828_RESET="PA26"
CONFIG_VIDEO_LCD_SPI_CS="PH9"
CONFIG_VIDEO_LCD_SPI_SCLK="PH10"
CONFIG_VIDEO_LCD_SPI_MOSI="PH11"
CONFIG_VIDEO_LCD_SPI_MISO="PH12"